Maybe a start, but.... Thanks for the thoughts. Nate, I hate to sound really stupid, but when you say to get a good test light, you mean the...
I have never had trouble starting this 1952, 216 engine until this weekend. Started fine, started out the driveway, and it just stopped. Fuel...
Thanks, I'll check it, Larry! Eric
That's a great picture. You say that the power goes to the bottom terminal -- its the red wire in your picture. But where does that wire come...
Well, this is really the question. Some line must bring the power into the ignition switch as a whole, so that one of the terminals then...
Sorry gang to come back on this one. I converted my truck to 12 volt with an alternator and am having difficulty knowing which post on the...
Hey gang, I have an original ignition switch in my 52 chevy. I just converted to 12 volt/alternator. y When I re-attached my wiring, the...
Hey gang, So I converted the 52 truck to 12 volt this weekend, and used the Classic Parts alternator conversion wiring harness -- probably most...
Hey gang, I am mixed up on one aspect of the 12 volt conversion for my 52 chevy truck. Do i have to replace my starter switch with one...
Thanks for the suggestions gang. I get a kick out of Nate saying if he can do it, anyone can. Somehow I suspect that is not quite so!!!! Eric
Hey gang, I have read many of the old threads on 12 volt conversions, which are great. What I couldn't find is whether anyone recommends a...
I got the harness a couple years ago, and I found it extremely user friendly, and I'm an idiot! Tech help was very good too. Just Learning Eric
Hey gang: My 52 Chevy truck has a nicely functioning 6 volt system. I hate to change it to 12 volt. My only gripe is that the old 1947...
Hey gang, I have the classic parts turnsignal, and just got the 6-volt flasher that I apparently need. Two questions. How are most of you...
Hey gang: I am sizing up my two part headliner to get ready for my weekend installation job. I can't figure out what the middle strip...
Hey gang, I know there has been a lot of entries on installing headliner, which I have studiously printed, but I must have missed this one....
Hey gang, I have been having some trouble with new master cylinders leaking from the boot area in my 52 chevy truck. I will trying a new one...
Stupid question By the way, once the allignment tool is in place, how do you get it back out when you push in the transmission input shaft?...
Frustrating I guess it is a tribute to Chevy Duty (or Classic Parts). They didn't have the size pressure plate/friction disk that I needed for...
Clutch allignment tool? Now I'm stumped..... A clutch allignment tool? Don't have that, and don't know what it is or where one would get it....
Separate names with a comma.