Quick tip... Easiest way to find vacuum leaks is to run the engine and spray brake clean around the intake manifold gaskets and any and all vacuum...
Most likely is the ignition but it could also be the tumbler the ignition switches. start with trying a new key/ignition assembly. you will need a...
use a long, strong length of thin rope and put it into the channel of the glass rubber. lubricate the rubber with soap . put the windshield in...
Put a set of 31 x 10.5 15s tires on it..... also you could put a set of exhaust headers on it to get a bit more torque.
does it do the same thing off either tank?
it ran good for a year and nothing had changed before this happened right?
you could try hooking up the gauge to a speedometer cable and spinning it with a drill... to get the number you want.... or can you swap the...
is the motor carburated? does it have a temperature gauge in the dash?
you didn't say if you knew which wire was for the wipers...i believe the washer fluid is controlled by the wiper delay module...if your column has...
what i suggest is start by taping the glass up so it won't fall.. duct tape.. remove all the fasteners for the entire motor and lift assembly than...
Count the teeth on the crown gear and count the teeth on the pinion gear, than using a calculator divide the crown gear number with the pinion...
you may need to change the clutch pedal assembly to an older style mechanical setup as well as install the clutch pedal pivot on the frame that...
did you get the right kit? Do you have an a/c re and re machine? bring it to an automotive shop and have them recharge the a/c and retrofit it to...
Bring them to a machine shop and have them press out the old bushings and press new bushings in.
it would be easier to put your body on a 2wd chassis.
Unless that air filter is completely clogged than the problem lies elsewhere.
Valve seals? Have you tried replacing those?
shouldn't be that hard to find at a junk yard.
heat the metal in the center of the dent to shrink the metal as you bring the panel back out. if it oil cans in again try again. when you pop in a...
That would be the rocker panel. It will need to be cut out and replaced with a new one. You can buy replacement rocker panels. If you don't trust...
Separate names with a comma.
