OUCH....Ol'Chebby is right, there was a major malfunction in the build. Let us know what happened, knowledge is power....and I am having a black...
Here is what I remember from a long time ago. First water expands and has to go somewhere, hince the overflow tank. It will fill and empty as...
If I remeber correctly there will only be a porpotioning valve when you have disk/drum set up. Going back to original statement that the pads...
If your getting from 9-13 mpg then your in the range of what I was getting on my 1970. I have a 99 tahoe that gets 12.9 to 13.2 in town so things...
Does anyody know the correct, actually the factory, pinon angle on a 1966 short bed with the ladder bar coil spring rear suspension? My brother's...
You might want to take the front bed bolts out and loosen the rear ones. Then you can jack the front of the bed up and access the lines from...
Just lay the new ones over the old ones to check for the proper size and width if you are referring to the drum pads. I am not sure if one is...
It has been about 15 years since we took the 3 speed out of the 66, but if I remember correctly the imput shaft if held with one bearing in the...
Everyone I talk to has a different opion about sand blasting. One, it opens the metal requiring more paint. Two, it could distort the panels,...
I am going the other way from 2 wheel drive to four wheel drive. I have a 1978 3/4 ton crew cab that I swapped the front diffential, springs, and...
While you are getting the flywheel resurfaced get a new throw-out bearing. If you have another transmission that you are not using take the input...
Has anyone swapped a 1997 7.4l port fuel injected motor into the 1970's body style truck. I am looking for a air intake system. I am not sure if...
You might have broken one of the pieces on the pressure plate. This would cause the shift fork to push the throw out bearing in but not release...
Sorry hope this is not to late. I had similar issue on one of my brothers 66 short bed. It turned out to be the brass sleeve that held the bulb...
Glen71, just wanted to give you kudos for your message and willingness to take the time to lend it out.
I can't tell from the photo, but it appears you have an aftermarket chrome theromstat housing. You might want to get a stock one or a more...
Sounds very familiar, You want to get it apart then realize there are a lot of steps left. I am frame off restoring a 1978 crew cab and wise I...
I just replaced the ones in my 1978 crew cab. The rust was not nearly as bad as what you have there. I did them with the cab off the frame, as...
Just a little info for the engine wiring aspect. I recently purchased a complete harness for a 7.4l port fuel injected and 4l80e for my 1978 crew...
Check with your high school auto shop teacher if you have that program, assuiming at 16 your in school.
Separate names with a comma.