you need to find a front clip from a 1973-1980. unless you want to change it over to the 81-87 style which was more "sloped" in the front. check...
i'm ordering a 1406 for my 350, and my question is, will the stock accelerator and dedent cable from my 79 work on the new carb? or do i have to...
well i figure anything is better than what i have on there now, plus i already spent a pretty penny on the bell tech lowering kit so i'm thinking...
i was wondering if anyone has bought steering components from here? if so, are they any good? because i'm lowering my truck, and while i have...
dang...fiber optics in my truck? haha :p i don't think it works anymore though...i just pulled it out. although it would be kinda cool having...
also i found this little guy bolted to the top of the fuse box and only connected with the clock power wire. they were both connected to the same...
here are the pics of the mystery wires. one's attached to a light bulb on the gauge cluster and the other three come out of a bundle of wires...
i really want to change around my gauges to eliminate the factory clock (that doesn't work) and replace it with a small fuel gauge. then install a...
i found the ground, cleaned it up, and then noticed that the circuit board wasn't tight because of some of the light bulb connectors were loose....
so a friend of mine suggested that i check the ground for the gauges, a poor ground could cause the gauges to not function properly. soo now my...
thanks David, sounds like i've got some things to do today :)
ok so today i replaced my alternator and oil pressure sending unit in hopes to cure my gauge problems...but even after the new parts went in and i...
ok so i found a guy that will pass my truck (under the table of coarse :p) so the first thing i want to do is strip off all the emissions crap...
i started with gutting the whole interior out of my truck, and replaced everything, sound deadner, carpet, seat cover, dash pad, instrument bezel,...
ya as of now if you have a 75 or older then you're ok, but anything newer, like mine, you're SOL... i've been looking for a 73, 74, or 75 short...
i'm pretty sure you're speaking of the lower grille panel. LMC sells them for $20. i can't imagine it would too hard to change out...but then...
ok thanks for the help, just have to go buy one now :p
i think i found where it is, i'm pretty sure mines next to the distributer on the right side...should be fun getting to :rolleyes: are there...
update on the voltmeter: worked fine today, read right at 13 volts...maybe it's just bad connections :confused: as for the oil pressure sending...
well first off, my oil pressure gauge always reads 60+ even after a fresh oil change and filter. i'm thinking maybe sending unit? also the...
Separate names with a comma.