Anyone around happen to have one? They were primarily used in GMC 2 ton and up trucks '40s through '50s. They are a big trans with a different...
Hi everyone! The past week I took out the ol 4 speed trans to get ready for a swap. There had been vibration issues for some time, I was...
I just switched out coil springs on my 1/2 ton C10 62 Chevrolet that had been lowered about an 1" to 1 1/2" with the springs still intact on the...
Here it is guys, this looks amazing! I am surprised that they did not make more of these. Whaddaya say?...
There will be an Online Impound Auction on www.towlot.com for A&B Towing Tucson on April 5 Thu Apr 5th, 12:00 pm CDT 10:00am PST | 11:00am MST |...
Howdy Guys, I took apart my driveshafts to figure out whats causing a big vibration on acceleration. I assumed the carrier or center bearing...
Hi Guys, just want to let some people know there is a new swap meet every Wednesday at 1501 W. 31st Street, Kansas City, MO 64108 called the Man...
Howdy guys, been awhile. I took my old front leaf springs off and found 2 caster shims under each leaf spring and Im not sure if they were put on...
Howdy Guys I am located in the Kansas City area and have been searching for the Eaton HO72 pumpkin with the 4.10 gears for my '50 Chevy 3600. I...
Howdy all, found this over on the stovebolt page. Enjoy! http://www.gmheritagecenter.com/gm-heritage-archive/vehicle-information-kits.html
Today I set the points because my dwell was reading over 50 deg. I started with .016 feeler gauge which brought the dwell down to about 40 deg...
While looking for a rear pumpkin change out on my 3/4 ton I came across the Ranger Overdrive...
Hey guys, when I pull the Choke out on cold start it only works for a couple seconds and then stumble and shut off. Engine will run fine with it...
This is a cool rare intake, would love to try one of these. http://www.museumofamericanspeed.com/Collections/Engines/RajoE033.shtml
http://www.jalopyjournal.com/forum/showthread.php?t=528122 Check it out guys, very cool! The device sitting outward above the middle of the...
Okay guys, might be a silly question, but when doing the timing y'all talk about plugging the vaccuum advance port, what is the proper way of...
Howdy guys, Ive been reading alot about changing the low gears in the rear end of my truck. Ive got a 235 with a Four on the floor. Im assuming...
Howdy everyone, my question is, if i replace the transmission and rear end fluid with Synthetic lube would it be wise to change the motor oil to...
Howdy guys, a couple weeks ago every now and then when i was in 1st or 2nd gear with clutch in the transmission would start rumbling. Checked...
Howdy Guys, New here. Have a question about the windshield wipers in my 1950 3600. The wipers stopped working one morning and I've been working...
Separate names with a comma.