Dowel pins What I should have explained is that there are 3/8 in dowel pins on my 235 engine With the old sm420 transmission it was not a...
I have a 1950 3100 I am putting a T5 in I am having an issue with the alignment the dowels look to be 3/8 inch dia. Does anyone know if they...
I am getting ready to put a 10 spline input shaft in my T5 My present transmission is a SM 420 which is giving me trouble The 84 Jeep input...
Did not pull all plugs I pulled the plugs one at a time and did not open the carb wide , and the engine was not warm . Second time around...
Thank you Come to find out I was doing the test wrong. Thanks for all the help really. Ended up with 140/137/142/143/138/136. D....
I have a 235 with 500 miles on the rebuild of bottom end and 300 miles on top end rebuild. New pistons the works, the rings are Crome. Break in...
I have a 1954 head and a 1959 block and I have read that you need to drill a center head bolt with a 1/16 in hole to get the oil to the rockers....
Thanks both of you I did have the type of resistor u posted and I agree it got way to hot. Just bought a 12 volt fan. But the issue I...
I have one of the voltage reducing resistors for the 6 volt heater motor But it gets way to hot. So I ordered a 12 volt fan motor but in my 6...
Thanks Larry. I checked the page thanks for the info but the piece I am looking for is not in the catalog The piece I am looking for fits on...
Does anyone know where I can find the insert fasteners with the rubber insert for the 1950 chevy truck vacuum wiper motor smm 412 2 it requires 2...
Fuel gage problem Same 6 volt fuel gage / New complete wiring system / Followed the print / Good ground / New sensor / seems to be...
can u wire a fuel gage backwards? Or will it burn up I wired the gage the way i thought it was before the only differance is i converted to...
Thanks again Nate
Is there a differ on the wiring of amp gage when converting to 12 v which is in and which is the out post on 1950 truck gauge. Thanks for...
I would think so also As long as it is enough oil right
Thanks again Nate The new shafts are aftermarket not NOS but do seem to be getting oil out the rocker vent. Thanks again for the info. :)
I recently bought new rocker shafts and the oil holes are smaller. The placement is the same but the new one has smaller hole. Old holes are...
Thank you Nate I really apperated the info Thanks again
Can someone please tell me the proper tdc on my 235 flywheel. It has the bb installed and it has a triangle stamped in it approx 1 1/2inches away...
Separate names with a comma.