62 motor mount perches

any suggestions for installation of v8 perches on a 62 frame with no holes in frame previous engine was a 6 cyl also goin with th350 from a 3 on the tree will the tranny fit? it also has the low hump. thanks

 

Tranny will fit. dont know what to tell you on the mounts other than measure twice and drill. I can get you the measurements this evening if you like

 

will the aftermarket perches for a 63 fit this frame

 

not sure maybe DValentine can answer this for you. what are you going to do with the inline 6?
Does it run? Dispalacement? i would be interested.

 

ran like a top I sold though it was a 235

 

never know till you ask thanks though

 

There are some aftermarket perches that are advertised for 64-66 trucks that will fit with some work. I can't remember "who" makes them but will make a point of looking it up.

Val

 

Not Sure if This is what Your looking for or not . http://www.brotherstrucks.com/prodinfo.asp?number=ESM6372

Best of Luck . Bob

 

Yea, that's them.. They were/are manufactured by someone else, who I was trying to remember. I see the"other" truck supplier, who is NOT one of your SISTERS, picked them up.

Val

 

Sixty Two,

If you haven't found motor mount stands for your 62 yet, I have 3 or 4 pair available. Yes, you will need to drills holes on your 62 frame.
Here is pictures of some.
http://good-times.webshots.com/album/562519931YZHuGM?start=36

Here is photos with comments below photos of how I installed them on my 1961 (V8 with TH350 tranny).
http://rides.webshots.com/album/562303409RqEyqn?start=48

Brian
cell 507.456.3625