Î bought last weekend a 235cui from 1954 for my 1946 1/2 ton and now i need some parts. I need a Balancer with 2 groove - 1 for normal parts and the second for power steering. Where is a cheap vendor for this? I took a look on damperdoctor.com but i think about $450 is too expensive. And could somebody give me a recommendation concerning carbs. i would like to use 2 carbs with the Fenton intake from Patricks. Volker
Hey Volker I have a 1954 balancer in good condition for 3/8 belt. Not shore which carburator modell/Brand carburator you want to use , but i have a Rochester B with manual choke and and a Rochester BC (autm.choke), both are looked over and in good condition. If you are intrested be kind to send me your e.mail adres. Regards Martinius Berg/Norway martinius.berg@bluezone.no
balancer Hey Martinius, a pulley with 2 grooves?. That's were fine. Could you send me a picture from this?. volker.hennig@q-pack.ag
Volker , hold out for a pair of Carter YF carbys , look in older posts for the correct # , it'll stamped on each and every part of the carby . Make sure you get the correct one for a 235 , the 216 ones have a smaller base and won't fit the 235 manifold . Be aware these are not cheap carbys ! . You clould begin with just one YF and see how much better it makes your engine run....
