ifs front Another low price option is the 71-78 van front crossmember. The van is necessary for the TF trucks because the pickup is too narrow....
Finally getting access to mill for carving out my ohc 302 GMC head. Have decided to go with a single ohc because the sample I very crudely cut out...
You actually need to take 2" out since the tires on regular wheels are out an inch on each side.(0n a half ton). You will also have to take the...
It's just not Auto Zone, all the chain stores have people that only know how to punch keys on a computer. If it's not on the Holy Grail of a...
We finished up a 1930 Plymouth "U" model early this year and one source we used was allpar.com and also Roberts Mopar Parts. There are several...
brake rod thingy Start shopping, I think I have the little sucker. Now if I can get this pic on the site. It's off the right side and they would...
brake parts Brit50, sorry for the delay, been very hectic getting a 1912 International ready for show. Will look tomorrow, monday October 2nd,...
It could very easily be a goof on my part also, when I tried to reply there was a flash that said I had gone over the one thousand word limit on...
Have a 50 1/2 ton that we used as a guinea pig for our first S10 conversion. If it has the round rods instead of the flat forked bars they're...
Guys, the 51 chassis has a new home. It went to a retired school teacher (we know how rich they are) that still cares for his 89 year old mother....
Brit 50, don't be too surprised if you might could make it. It probably wasn't featured in your papers but over here some Cubans rigged up an old...
You know, Nate, my shop has become the type of shop I used to hold in disdain--the home of the high dollar ride. The guys still seek my advice...
Strap a seat on it along with a gas can and battery and you can drive it. Split manifold with new exhaust, brakes, alternater conversion, etc. Has...
67-72 chevy pickup or van. Van is shorter. Both use dash switch. Non tilt are still fairly easy to find, not so for the tilt.
Kent, you contacted me through the private message thing but with my usual computer skill (zero) I just get an "error occured" alert when I tried...
It could be titled as any year but even your not real in the know friend should be able to tell if it has a one piece curved or two piece flat...
Where are you located? We have done several streetrod 47-54 trucks so there is a pile of running gear parts left over. Getting a whole rear...
Since your truck was offered with a V8 and auto all the necessary chevy eng/trans parts are available cheap and plentiful and would be a bolt in....
While at the shop of, Jerry Willis, in Princeton, Texas I had a conversation about 235 powered race cars since I had heard he had a 39 chevy coupe...
We have TIG, MIG, oxyacetylene, and stick welders. Each is good for specific needs and some for several. Beginners seem to do best with the MIG....
Separate names with a comma.
