I'm pretty sure all you need is the switch and the delay module. At least that's how it is with the '84 and later.
One thing I forgot to mention that might make doing the front easier; as long as the gears are the same, the only parts you need to swap are the...
I ended up just using the Suburban's seat tracks. All I had to do was bend the rear mount up to match the angle of the pickup floor.
Axles will bolt right up. Without the shafts just requires a conversion u-joint for the rear. (Napa #447) If you take the trans and t-case, it...
Have you looked at the fluid at all? Do you know when it was last serviced? If its low or smells or looks burnt that could be part of the problem...
I've done 4.3 to 6.2 (same mounts as a SBC) on my '85. 4.3 engine mounts are farther back than the SBC, so you may need to grab engine mount...
There is no difference. K5 is the badge/common name for Blazers and Jimmys, but all have the same suspension as a 1/2 ton pickup, so they're...
It will probably be cheaper to go to a junkyard with a multimeter and look for a Silverado and pull the harnesses out of one (one under dash, one...
There is no difference. Most Fullsize Blazers/Jimmys got a K5 badge, so that has become the common name for them. But in title, most are...
I just did a gas to diesel swap earlier this year. Having a donor vehicle definately makes it easier, and if you have the correct wiring...
1st tip: Get the right tools, a steering wheel puller and a lock plate puller. It basically requires 2 people to get the snapring for the lock...
I'm not too big into lowering trucks, but from what I've read in these forums, you might be better off buying either a set of drop spindles and/or...
I have a pair of seats from an '87 Suburban I want to put in my truck. The seats are blue (velour w/ vinyl back) and my interior is black. There...
Has anyone taken apart or know how to take apart seat tracks? I bought some bucket seats from an '87 K20 Suburban to put in my C10. I also...
RE: 1968 GMC Jimmy is it worth sav '69-'72 are the years for the first gen Blazers and Jimmys, so they can be hard to come by. If the body and...
There is a vin on the frame somewhere that will tell you which truck it came from. As far as the suspension strength, look at the axles; if...
Same as the front 10 bolt.
If your axles are stock, it will have a 10 bolt front (8.5" ring gear) For the rear it will be either a 14 bolt semifloater (9.5" ring gear) or a...
I dont know whats required, but I know people have put NV4500 (5-speed manual) into their 70's - 80's trucks. My brother wants to put one in his...
I bought a center console from a '82 Blazer to put in my truck when I install bucket seats. I've taken apart standard latches on glove boxes, but...
Separate names with a comma.
