Do you know if your block has mounting points for power steering brackets. I have one some where off a 84 straight 6. I beleave there some pic's...
I beleave that the 16.5 rims will fit the big three so. They all went in on them to keep cost down. Since they all did not make as meany as the...
I have to guess bad connection - sender is bad or dirt is in the sender oil rush in jams the sender pressure reading up to high. Needs a sender...
So LMC does not sell them any more?. Well did you try here? I all so posted on you other Q about the same thing.
On this site they sell them, click on the classic part logo go to online parts look them up or LMC sells them too. Your looking for one for the...
Well all the 73 - 1987 steering shafts come looking like pic two ( right ). I do not know of any way becauce I never tried working with it, but...
I would take it apart to check it 3.73 turning for 60 miles no fluid could hurt it. I would put in good fluid new gasket some addive of your...
Ok that single wire IS for cruise control if you do not have it on you truck, just leave it just tape the end tape it to the housing out of site....
I not sure if it's the cable or the speed sensor try here http://www.classicparts.com/default.asp to see if they got what your looking for.
Well used door 77-91 your inner door panel be a drict bolt in on 77-1980 after you will have to do some small modes to get them to fit. But not...
As said by the last post if your trying to keep heat out.:)
Do you have the clam style motor mounts on your 454. If so you should not have to change them. is the 454 from the 73-87 with clam style mounts...
reply in other section you asked the Q? I do hope this helps you.
http://www.classicparts.com/1987--Shop-Manual/productinfo/04-045/ ok this is a hole manual price is higher but should be it. look like they do...
I might have somthing but it will not be as good as the one that they Sell here on this board. check out parts in the witen section under 1987...
Do you have the right sending unit for the gauge. The sending units have built in resistince to work what ever gauge it was set for and temps are...
ok then here some more C-15 2wd 1/2 ton K-10 4x4 1/2 ton C-25 3/4 ton 2wd K-25 3/4 ton 4x4. Now...
You still might want to take the front tires off, and support the frame at a low distance that you can move you picker but will let you picker get...
C = 1/2 ton K = 3/4 ton .
If it for a 73-87 try this site.http://www.73-87.com/chevy_ids/sbcid2.htm hope this helps. Pontiac1976
Separate names with a comma.
