Is anyone going ??? dv
Hi Rus-T65 !! Love the truck and the stance !! If you gotta Go ? Go Low !!! You need to get out more Leyland !! ;) dv
Nice Job !! :)
Lee, I asked the question on another forum and this is what I got back. That being said, you could still see a "harmonic balancer" on...
I did the same. Went from 6-9 mpg to 18-22 !!! RPM's at 70 mph were 1900.. dv
Great post Leyland ! Were not the early 327 & 283's "internally" balanced ? In other words,,, no external balancer on the end of the crank...
Rust Mort is meant to remove light surface rust before painting. ( if I remember correctly.. (?) I've been hearing good things about this:...
Your instructor was a wise man.. The first thing I did was to rip out all the creative wiring that had been done over the years, returing the...
It's NOT a good deal !! Find another muffler shop. They should be able to run a full set of duel exhaust WITH mufflers for about the same...
Oh Yea !! I forgot about the foam pad !! my bad.... Dennis
The block casting numbers are located on the bellhousing flange below, ( and behind) the left cylinder head.. dv
If the 4 speed is the SM420 then NO boot goes over the shifter tower. Only the boot that seals the shifter arm in the interior is needed. dv...
Great choice !!!
Thanks Easter Bunny !!!! Great work !! Summer cruising is looking up !!! dv
Is it the "correct" sender? Where did you get the sender ? It may not work with older guages if it's a generic sending unit. Much like the...
I can't help there... May need to look for guage clusters on e-Bay/craigslist.. Are you positive it's the gauge and not the sender ??? dv
You can go up to 66 for a perfect match. You can also go to 72 and it will all bolt in, but will be 3/4 wider per side which could require a...
Try to slightly mosten the door bumpers with a shot of WD-40. Use a larger center punch with a flat top and "gently" push into the holes.. dv
Finding exhaust headers that fit will be a problem... The driveshaft should be measured for after the motor & trans are in. Shortening a drive...
Go with the carb and manifold. Edelbrock 600 cfm for economy, Holly for performance. dv
Separate names with a comma.
