1.5 with flomasters is a waste of money. Perfomance exhaust without performance pipes. 1.5 duals will work but don't expect much in the way of...
http://store.summitracing.com/partdetail.asp?autofilter=1&part=SUM%2D730306&N=700+115&autoview=sku OR...
Squirt the bolts with PB Blaster. Locktight also makes a product that freezes the bolts causing the bond to break. This allows penetrant to seep...
I'm not sure how you will be able to get the core out of the ignition. If you have a key you insert the key and push the pin in with a paper clip...
http://www.classicparts.com/1947-66-Ignition-Switch-Cylinder-w_Key/productinfo/53-475/...
It's been a few years but I think I paid about $150.00 to have it shortened, balanced and new U-joints. Did they take both pieces of the drive...
Edelbrock performer intake with edelbrock performer 600CFM will give you good results. If you have a 283 order 2701, 27011, 27014 intake...
http://www.daytonabeachcarshows.com/
If your are looking for good gas milege or highway speed then you'll have to ditch the 4.57. It probably goes like hell til you hit 60 mph. I...
Which axle do you have? Is it the 12 bolt? On the twelve bolt axle to go lower numerically than a 3:73 you will have to change the carrier. A...
Nothing kills rust. You can either encapsulate or remove it. POR-19 is a good product to use but you can't prime and paint over it. It is a good...
IT's not worth the money. Run a 2 1/2" dual exhaust for better performance. If you just have to do it add an H pipe. All it does is equaliize the...
You might be able to get to the numbers with the intake removed. 2,3,5,6,8,9 look very similar on the block so take your time.
Here are two sites to help you out. Your old speedo cable will thread into the 700R4. You will need to know what gears you have. You will have to...
You can go down to 3:73 but to go any lower you will need to change the rear carrier....
Would I be better off to change th e manifold as well? as opposed to an adapter? YES. Edelbrock performer intake with edelbrock performer...
It's only worth it when you need it. There was a few times in Alaska that the one wheel wonder just wasn't getting the job done. I did think about...
There is no bolt in kit for a big block that I know of. To put in a small block all you have to do is change the pearches/motor mounts. Correct me...
I have recently been having some electrical issues with my 66 and I thought I should share them. I am an electrician by trade and thoroughly enjoy...
Is it a BB 400 or SB 400? Do you currently have a small block v8 or the inline 6? Is the tranny a short shaft or long shaft? We need more info to...
Separate names with a comma.
