I can't find the front motor mount stands for a 56 with a V8 on our hosts site. Can someone give me the part number if available or someone else...
Thanks, Big Tim, but he float level has been multi-checked and also raised/lowered in 1/32 inch increments---all to no avail. The rubber and steel...
Try this before going on another carb hunt, especially since your present one is good except for cold starting. Take the air filter off and set it...
I am asking a question and I now know what the new guys that open with "this may be a silly question" feel. My computer is a 2003 model which I...
The strips are usually rusted to several inches up from the floor so we usually just plasma cut a new flat set out of 1/8" flat stock be it steel,...
Until I was in my mid-teens my greatest envy was of neighbors that had electric start tractors. Our John Deere was started by pulling on the...
Another AD is getting close to the door. It's a 54 with a one piece power tilt front end, MII, P/S, P/B, A/C, recessed power antenna, 200R4 behind...
A good friend that is also my driveshaft builder drug in a very sorry 1957 Cameo and asked if it could be saved. A lot of the usual rust but the...
Russ is right, length is no problem since a V8 is two cylinders shorter than an inline six and width is no problem since your changing the...
Here are two Mariner Blue trucks, R-M code #211, at a car show near me. Both trucks look to be close to correct in the restorations. Your paint...
Ken, Neils explanation is perfect and since you are a Sherlock on the computer you can go to www.wescottsauto.com, click on "tech", and then on...
If it worked like that my left leg would be worn out from stomping it.
For what your wanting you could use an old tach/dwell meter to get the information you want and forget about mounting something to the dash or...
Aways been a tool nut so couldn't believe my good fortune when a friend said there was a GM frame jig sunk into the ground in one of his fields. I...
Here's hoping for the best possible outcome and kudos to you for being aware and staying on top of the situation. My Urologist has me on a twice a...
Sorry it's not an AD but is a sample of our work. We converted it from right side steering to left side since it will be France the majority of...
The price of a Pertronix kit is $80. The HEI your looking at $69, S&H $10, new plug wires $30 (your old ones won't work), machine hold down flange...
Pull coil wire. Bump engine over with starter till rocker is in it's uppermost position. Loosen lock nut on adjuster screw and back adjuster screw...
Your 3.73 gear will be pretty shallow gearing in overdrive. I always thought an old Borgwarner was a 30% but Nate says 33% so I won't argue there....
If you get really good at this please contact me, we would find someway to put you on the payroll. It is a trying job (pun intended) that consumes...
Separate names with a comma.
