Do you still want to use it as a truck or just a cruiser? If a truck then the minimum work all bolt in set up is a 67-72 3/4T differential from a...
I didn't think of Heim joints with female threads, would be much easier. We have always used the ones with the male threads which require a...
Martinius, Here is what we use as a rule of thumb in selecting longer push rods. Up to 25 cm one about 10 mm in diameter, 45 cm long about 12...
Been through this several times and found they are located right between hens teeth and unicorns. The frames are being reproduced by someone now...
There has been several discussions on master cylinders and one topic is with them not fitting and/or clashing with some other component. This...
90wt is fine as is 80-140. We use Torqo in a lot of the ones we do but it will leak from areas regular lube doesn't. Both use the same lube since...
I never had any luck trying to set multiple carbs with both functioning. There is a tool called Uni-Syn that is not expensive and has good...
This was a problem when we used to go from the factory 16" wheels to the 15" ones. Rim hits arm/tie rod right at outer edge. With all the 17, 18,...
Old Friend, Glad to see you'll be around to get even older. I would have guessed you at more than 6-5 but that was plenty enough to have that...
Most trailer manufacturing/sales/supply places have the spring saddles (perches).
Wolfgang, Another thing you might consider is to send your wiper motor to Ficken Wiper Service in West Babylon, New York and have it...
Did they make 3/4T AD 4wd's? I know the earliest NAPCO 4wd ones I've seen are 55 2nd series. Fellow brought a 54 3/4T 4wd that sure looks like a...
I replied in to a thread that at one time I had 36 AD trucks and got quite a few PM's about various parts. First, our host and ones like Joe at...
Probably what they were referring to is on cars/trucks with a bypass wire from the starter solenoid to the + side of the coil which when using a...
In the 1970's I had 36 AD trucks split exactly even with 18 5W and 18 3W. There was only ONE GMC, a 51, and that's what the man wanted. Here it is...
Can't tell much from filter shot but if it's mounted down on the block instead of bolted to the intake manifold there's a good chance it's a full...
See where the flat lever pushes on the round starter button? Tape something about 1/8" thick to the lever or have someone hold an something like a...
Hagan offers vent window eliminator kits for many vehicles but you would have to check to see if they have what you need. They're good to deal...
Andy, You DON'T need a booster on good working brakes if the kids can stop it okay or for someone like Nate with a physical issue. If it will...
One more time: Measure between the holes on the rear bed crossmember, the one where the boards fit down onto a little shelf. This will give the...
Separate names with a comma.
