bad brain Already having the parts is bad thinking when it comes to the wrong parts. The aluminum valves are just wrong. If they are leaking it...
That blue residual pressure valve looks like anodized aluminum? They suck and are designed for race purposes only not for street due to corrosion...
Did you flare the ends yourself? If so, it may be your flares. Hard to do correctly. Ask me how I know. Andy
Tranny swap Listen to Coilover. He has decades of experience. It's his business. Also, if you decide to swap out the trans, the Muncie SM420...
Just...don't. Andy
Did you put the lock washers back on the carb studs after you installed the carb on the studs? Did you forget to put the spacer back between the...
^^^John, What is this backing purge tape of which you speak? Andy
Pics Evan, First go to photo bucket and choose the picture you want to post and click on it so it gets big. To the right of the picture there...
I upgraded to front disc and put a Nova rear in my truck at the sme time. The Nova rear has SMALLER drums (8") than the stock drums and my truck...
Front disc If you go with the front disc conversion from Buffalo Enterprises http://www.inliners.org/buffalo/ you don't have to worry about...
The answer is yes. They just slip on the studs and are held in place by the wheel itself. I had to use them on the front of my truck when I...
Depends upon where it is leaking from. If the pump has been on there for a long time, it is not likely a gasket leak. Look closely at the pump...
Porch Bill, At the yellow arrow in the below picture, how is the new rear 1" X 1" tubing attached to the porch? Does it lay in the exact...
Porch Hey Bill, Instead of building that "porch" can't you just use a spacer to bring the rear of the seat up enough to clear so you get full...
Lucky Bill, I remember some time ago when you first told us you were looking for such a seat. I began searching craigslist for one but gave...
I have one of those Astro van seats in my shop in storage. I thaw those brackets on the bottom also. I was going to use it as a back seat in my...
Looks Great!!! Good work, fellas. I was wondering when you were going to post a tech article on that. Looks awesome. I would love to find one...
If you don't want that original heater when you are done with it, you can send it my way. I could use the heater control valve and the rod and...
Drop it into the frame as-is, read up on Nate's advise on how to revive an engine from a long sleep and get it running. I strongly suggest new...
What Nate said I followed Nate's advice years ago. I put a note up on the '55-'59 forum looking for a "good running" 235. One of the nicest...
Separate names with a comma.
