Search results

I had just finished installing a Derale dual fan with separate electronic thermostats. This after rewiring the entire engine with new wiring and routing from "The New System" out of California. The stock wiring ran from alternator to battery over the radiator and the last thing I did after...

My driver's side upper shock mount won't stay tight. I know this is a problem area for these trucks as the mounting point for the shock is only fixed at one end putting lots of leverage on the single mounting hole in the frame. I have found some aftermarket fixes available (Western Chassis...

Background: I6 292, Weber 38 carb w/electronic choke, Clifford intake/exhaust manifold, Mallory Unilite distributor, carbon spark plug wires, new alternator, all new engine wiring harness, Derale fans off dual thermostats. It started every time in 4-5 revolutions, ran fine with no...

I have a '63 LB Fleetside and am replacing the wheel bearings. I have the manual that I got from our hosts but I can't find any mention of wheel bearing replacement in it and there is no index. I will keep looking but can anyone give me a quick doublecheck on replacing rear wheel bearings...

1963 C10 w/292; I am planning to replace the distributor with a Mallory Unilite pointless distributor the instructions emphasize the necessity of either a ballast resistor or a loom resistance wire between the ignition switch and the coil. I didn't see anything like a ballast resistor but it...

I just drove the 63 C10 I bought in September from northern Washington State to Albuquerque NM. It took five days and the stock 292 just purred along (at 50 mph) with not one problem. I am blown away and very happy. I do have one question: the 4 on the floor tranny clatters very briefly...

I am sure that this sort of question has been asked before and I did do a search but nothing came up. I just bought a '63 Fleetside Longbed and the guy who sold it says it's a 3/4 ton. I bought the '63 Chevy Truck manual and unless I am not understanding (a reasonable possibility) the VIN...

I just bought a 63 longbed fleetside and I don't have the truck yet and was wondering what the total length of the vehicle was bumper to bumper. Thanks.

Greetings, I am new both to Classic Parts and to being a Chevy truck owner. I just bought a 1963 C10 Fleetside Longbed w/a 292 and four speed. A new project!! Does anyone have a recommendation for replacing the 1 barrel stock carb? I do not want to do any extensive engine mods so I am...