I just posted my 1951 3800 Chevy Panel Truck for sale in trucks for sale section
1951 3800 Chevy Panel Truck for sale, Southwest MN I acquired this 1951 Panel in August, 2014. I moved it into shop in late summer. This...
I want to say Thank You for your Prayers and thoughts as I went thru the medical procedure yesterday. Doctor said Everything went very well and I...
May I ask for your thoughts and prayers as next Tuesday I will be admitted to the hospital for Cryoablation of the prostrate. Hopefully life will...
Does anyone have any plans or pictures of their rear bumper set up which would incorporate a receiver hitch on a 1 ton. I just smashed beyond...
When a 216 Bell housing and Flywheel is installed on a 1958 235 engine, My understanding is the BB is Top Dead Center, Is that correct? When...
Fenton headers on a 1958 chevy 235 engine going into a 1951 chev 3800. Did test run today,6 miles around the country block. GREAT RUN, Except for...
A couple of questions in preparation for swap. This is a 1951 one ton truck with the 2 piece drive shaft. When removing the drive shaft, will...
Part # 1158514, Has anyone used or Is anyone familiar with this product? I have one bolt on the water pump that is into the waterjacket and need...
What are the Pros and Cons of drilling and tapping the 2 bottom holes into the engine block for timing gear cover so removal and re-installation...
235 engine, 1958 , 3836848 head. Is the correct torque 90 to 95 ft/lbs? I read that value for a 1955 235 engine head torque value. Thanks, Jerry
I Got to see and help remove 235 engine that will replace my 216 engine in my 1951 one ton. It has been installed in a 1954 Chevy car chassis. The...
Here is the situation. I have a 1951 chevy with 216, 6 volt electric system, Engine still runs and I have plans for it going into a 1946 2 ton...
Last December, I aquired what was described as a 1946 one and a half ton truck. Now that the "Winter from Hell" is subsiding I started looking to...
I have a 1951 1 ton with stock axel and Eaton HO72 4.11 third member. I keep reading about reversing the rear springs to center the axel. Is this...
Separate names with a comma.
