Im on round 3 of oil pan surgery. How can i mount the gasket the easiest please? 4 piece gasket. quite frustrated.Does a single piece gasket...
Rear main seal is out of my 54 chevy 3100. New one installed . Should the bearing caps be torqued ? what spec and is the an order as far as...
I purchased a sneaky pete tool. I also loosend my crank (54' 235) a tiny bit to help but..... of course BOTH ends of the rear main seal ripped off...
ive loosened my crank bearings in order to get my rear main seal out. Half my seal ripped upon being pulled out. Anyone have suggestions on...
Got a small knock at when under load only. Itll idle "normally" even rev normal. Ive adjusted valves to Deve specs and still seems a bit noisy....
Ive purchased an external canister oil filter and upon installation, ive realized im not sure which is the feed and which one is the return? top...
any suggestions for purchasing new lifters for my 54 235? i know i know, no hydraulic..
Another newby question.. What oil should i be running in my 54 235? not having smoke issues but ive been using 30w non detergent. Good or bad? i...
Can someone explain why i can not shift into 3rd while in motion but it will at idle? i just replaced my 54' 235 engine with a 56' 235 engine....
Not sure if anyone has run seafoam product through their motor and if so recommended or not.? according to the inhouse email, they claim its safe...
I put a 56' 235 in my 54 pickup. Was i wrong in assuming that the gas pedal linkage would still be the same? the old one doesnt fit anymore. even...
Im a bit of a newbie but im converting my 1954 chevy floor start switch to a normal turn key ignition. how many terminals on the back of the...
Separate names with a comma.
