for a GMC [Chevy] with clam shell doors. A pair is preferred but a single will help too.. Thanks Bob [
My new project is lacking these. This is probably going to be a hard item to find but I figured I'd throw it out there. Any help appreciated and...
For a 63 Chevy manual trans. It's the center bell-crank type arm with associated linkage and large spring. Thanks Bob
WTB emergency brake bell crank and spring [I have cross member] This is for a 63 1/2 ton pickup
How many gallon gas tank does Classic Parts sell? I see that Chevy Suburban sold different size tanks..
Has anyone used undercoating under their hood? Any problems with heat with rubberized undercoating?
Iv'e used this tape before but forgot how. Help?
As stated need a transmission hump cover for a 63 1/2 ton. Got to be in good shape..No cuts Bob
I plan on upgrading my brake system to a dual master cylinder. What works with a 63 Chevy 1/2 ton with drum / drum? Bob
The manual says to align the pointer with the BB in the flywheel. When I do this the truck runs and idles ok but short on power.Dropping down the...
Let me try you guys..Iv'e got a Carter YF carb that needs rebuildind [throttle shaft bushing].Anyone know of a shop that does this? Thanks
Iv'e got a Carter YF carb on my 235 that has a throttle shaft leak. Where do you guys send your carbs for this to be re-bushed?
Timing my 235, the manual states to set timing with BB at the pointer. When I do this the truck lacks power and idle RPMS go down. If I set the...
Iv'e got a 55 first series pick-up with a 235 ci motor. Reading the manual it says to time engine with pointer at the flywheel BB. Well when I do...
I picked up two 6 volt horns, both high and low note.My question is..can I wire them in series and have them work correctly to replace my single...
Let me try this again. I picked up two 6 volt horns [high and low notes] Question is...can I wire them in series and have them work? They will...
I picked up two 6 volt horns [high and low[..question is..can I connect them in series and have them both work replacing my single horn? My truck...
I'm rebuilding a 57 Chevy and am looking for a 283 for it . Powere pack heads would also be a plus...Thanks
Hood emblem for 1954-55.1 $20.00 [ few dings] Side emblems look nice but some pitting $20.00 Rear step bumper O.E. GM Painted and straight...
Iv'e got a 55.1 3100 Chevy truck...three speed manual trans with a rear of trans leak. Short of explosives, any suggestion on getting old seal...
Separate names with a comma.
