I have a 8 prong plug on my tilt GM column (Delco Remy plug 08 67) and need to wire into the 1957 Wiring Harness ......anbody have a clue what...
Anyone have any idea what the correct direction of the offset washers is for the bed mount washers? ie...the large offset must go towards cab...
Since this harness has no provision for fuses, I installed a fuse for the headlamps and probably shoud put one from main power supply? Any...
Anybody know the procedure to change out the vent window weather strip on a 57 before I start drilling out rivets and breaking stuff ? LOL!...
ANybody know the correct locatioon for the V 8 emblem on 57 ? I've seen pics of them on the door - in line with 3100 emblem and I also saw an d...
Anyone have any idea as to the width of bed wood planks needs for 55-57 short box step side trucks? There are 8 planks used, but I am not...
Bought the Chevy Duty wiring harness for 55-57 with alteranator. Anyone have any idea how to wire in a fuse for the main power (think I...
Only a few trucks 55-57 on this years auction block. Of the 57;s I was surprised by the results Lot#44 - SOLD for $24,200 58 -...
Hey guys, Just tried the new photos section. Upload your pics there too, It would be great to see your projects in there. cheers...
I am using A Urethane paint and doing most of the paint myself. Is it possible to buff out any imperfections (orange peel, dust etc...) that...
[updated:LAST EDITED ON Apr-04-06 AT 08:03 PM (CST)]Anyone else find that the paint and trim codes are not exactly as printed ? When I...
What year and type of dual master did you use to upgrade from your original suicide system ? Looking for drum>drum and drum>disc or disc>disc...
I am looking for the emergency brake cable linkage. The piece that attached on the frame mount and connects to the front e-brake cable. Any...
Can i get a 6 bolt disc brake conversion kit that will alow me to change to 5 bolt discs later, without too much additional cost ? I'd like to...
Can i run an 11"clutch ? I had a 10" diameter come out of my 283 w/ muncie M21 combo, but when I measure it up it looks like 11" disc will fit...
I wanna run 5 bolt Corvette Rally wheels on my 57. This means new front hubs and a new rear end or axles. Any advice on the potential rear end...
Will the original type V8 motor mount kit work with the original tranny cross over (bolted at bell housing) ??? There is no location change to be...
K boys, the major grunt work is done, the CD cab corners and steps are all welded in, my truck is in several pieces right now and the only thing...
I replaced the cab corners and now I'm doing the steps. The sheet metal fits great , had no prob installing it Great Service and help from Chevy...
Anyone know where to find , or have them out there ?
Separate names with a comma.