don't go with gmc hood. the signal lights are impossible to find
you could try a different tranny if your interested in going that way. the newer 4 speed automatics have a lower 4th gear that would compensate...
i did this to my 62 gmc with the V6 and a generator. two years and no problem. all i had to do was get the alternator bracket off a newer V6(i...
35'S TOO BIG???? WHATCHU TALKIN BOUT.
I tryed searches and junk yards. nobody will sell just the part i need. they will only sell the whole front end for about $1,000. i did however...
it disconnects your battery just like you had pulled one wire off the battery terminal. Does anyone know if this would work on the ground wire?...
stick a screw driver in the inside hole at the bottom to turn adjuster gear. if you take the drum off you will see what i mean
Does anyone know where i can get nerf bars for a '62? I need the ones that bolt to the frame. I'm getting tired of jumping due to the 39.5's. of...
i can't tell by looking. try jacking up the back end and turning the drive shaft and counting the tire rotation. that will give you a rough estimate.
i tightened the input shaft. it took most of the play but then it felt like the steering was caughting on something so i had to loosen it back up....
it's the axle shaft i need.
where did you find those numbers? I'm trying to find my front axle code too.
does anyone know where i can get a left front axle(from the differential to the wheel)? I was replacing wheel bearings and found out it was...
casting number is 2386739. i don't have any stress cracks. yes, i'm interested in getting it rebuilt. i'll need an address to send the picture to....
it had a four inch frame and three inch body lift when i got it. sorry i don't where you can get either. you could try blocks for the frame and...
RE: 62 front right drum brake prob check the brake adjustment on the other wheels
does any one know how to tighten a manual steering box? It's in a 62 4x4 with about a quarter turn of play. this does not help with 39.5's. thanks.:(
it already is. but thanks anyhow
i am swapping out my v6. i'm assuming i need motor and tranny mounts. i'm wondering if i need to beef up the springs for the weight difference.
my vin # starts with K150. i know k is 4x4 but need to know what the 150 means. thanks for any help.
Separate names with a comma.
