Thank you Coilover. That is very helpful.
I don’t have to do anything with rocker panel or inner cowl brace. Just wondering if there is enough support to hold the firewall with nothing...
I am planning to replace floor and toe board and kick panel on the passenger side of my 53 3100. Is there enough rigidity to do this without...
Glad I could help. I’ve had taken my truck apart and back many times over the last 47 years
I believe they are supporting rods that go from the top of the radiator support down to the center of the grill.
I know this has been posted before, but, can one ton fenders and radiator interchange with 1/2 ton? Thanks, Jeff
To Classic Trucks, I would suggest that you take the ID plates out of your catalog. I bought one, took off the old one and now have learned it...
Through a series of unfortunate events, I am in need of a new AD cab with title. Anyone have one for reasonable? Thanks
I have put a used mustang II suspension in my sons 49 1/2 ton. After much thought and work, I finally was able to get the steering all put...
I've been looking at the heater in the 79 1/2 ton Chevy donor truck and am wondering if it will fit in the 49. Has anyone used this combo?...
I am looking for gauges which will fit in a 47-53 dash that are 12 volt for oil, temp, etc. I know I can purchase these new or rebuilt, but I'm...
Thanks for the info. I have a 49 I'm working on and just wanted to see is it was anywhere else besides the plate on the door post. Thanks again....
I know this is an old question, but I did a search and did not get any hits. Is the VIN located anywhere else besides the plate on the drivers...
Good morning, I now have the rear glass in the opening, but cannot figure out how to use the lock bead tool to get the beading in. Help would be...
Thanks for all the replies. They are very helpful. At what angle should the motor be set? Thanks, Jeff
I'm in the Phoenix area. Where are all those famous salvage yards with all the great trucks. Jeff
Hi all, I am putting a 350 with auto transmission in my son's 49. I have purchased a v-8 cross member from Chevy Duty. Can someone give me...
I'm lazy and untalented. Would you mind sharing the frame location of the small block cross member I purchased from Chevy Duty?
Hi all, What is the best way to take apart spot welds? Thanks, jm
Hi all, I am going to replace the wick rear main seal one more time in an attempt to stop the messy one drop. I was told to soak the rope in oil...
Separate names with a comma.