Thanks Mucho Bill thanks a bunch
I am looking for the front windshield inside trim clips. The piece of trim that goes in the cab at the bottom of the windshield . There are 8...
Reply Thanks for the feedback. Your web site is great and so much detail. Good work looks great. I love to see what others are doing...... sweet
Thought I would share this I am excited I finally have my engine and trans installed on my project truck. You can see updated photos here...
Brake Parts Hey Brad I think you send me an email a while back asking some of the same questions sorry if I didn't reply been busy. I used a...
Hey Bill I agree with you the less angle the longer the joints will last and less stress. I specifically looked at numerous 55-59 trucks at the...
Column photo another Here is a photo of the column and steering joints from engine compartment
Steering cloumn Mounting Steve I modified and used all of the original mounts for my 72 column. See attached file if it is there any questions...
Paul Sweet deal on the MFI that will be nice! I have been lucky on some good deals but I look and look and look day after day. My wallet is...
Re Steve haven’t got my motor mounts in yet but plan on using CPP. I have the full cross member similar to TCI one....
I agree with Steve If nothing else just set the cab on the frame and stick a couple bolts in it hand tight. With 4 people it goes on and comes...
Reply Hey Steve I am not sure on the exact position of the column. I don't have my seat in or the steering joint and shaft yet. The GoodGuys...
Steve Removing the rivets is a pain. I found a tilt steering column from a 72 Chevy truck I am going to use that. Just finished cleaning it up...
Installing your IFS Scarab I did install it myself. It wasn't that hard as long as you have some welding skills and a BFH. The worst part is...
You pickup or have picked up a left and right bed side very repairable small dents a couple samall holes but straight surface rust only. Off a 57...
I have a set of bed sides off a 57 Chevy 3200 they are 100" long. I shortened my frame and have no use for them they are in very repairable...
Repo Sheet metal The reproduction sheet metal available ususlly will not fit like you would think. I bought a right front fender for my 58 and...
There is a nice online calculator to help you figure out what you want http://www.angelfire.com/fl/procrastination/rear.html
Where I got my axles Actually I am using a 5x4.5 bolt pattern not the Chevy. I got my axles from www.northracecars.com/ a real nice guy to deal...
Rear Axle I used I have a 57 with a 58 front clip. I used a Ford 8.8 out of a 88 Tbird Turbo Coupe. It is a 3.73 limited slip with disc brakes it...
Separate names with a comma.