Sorry you were disappointed I was disappointed 10 years ago when I bought my second restomod project , after having so much luck finding info...
Ok I know I have been very bad and not visited in a long long time I am starting to work on lastest project that I bought over ten years ago I...
i am going to pull 216 drive line, 4 sp tranny,and acxels from a 46 chev. when i got the truck in aug engine ran buy putting gas down carb fuel...
front axcel i have a 46 that I am going to put a mustang front end on if that helps. not sure when i can get old axcel off truck. whanted to get...
seats are from 02 chev pick up, same as tahoe. did most of work , with help from freinds. bought the engine . from internet.
i am bad!! i have stayed away from forum for months and worse i have not worked on the truck in nearly 5 months. i got frustrated last October...
A measure of success I found the track and got the window in, after many tries and paint scraping!! Now i just need to figure out how to get the...
Door lacth When i spoke of the door lacth i was mean the remote control arm for the innr handle. The manual shows both running horizontal in the...
feelin dumb I looked at the manual, and looked for other post on this, and i still have not figure out the right way to install!! I can not see...
just to make all you fell better (except maybe brian) it is around 0 degs and 3-4 feet of snow in the yard. anyone want to move to ontario canada...
Off topic, what is the tank I was loking at your tailgate pisc, and noticed your gas tank. I was woundering what it is from and how you mounted it ?
i was wounder what anyone has done for running wires into the doors? am not putting in windows, (yet) but need wires for power locks and maybe...
the truck i bought has a 74 camaro clip on the front, power steering box, and the cross member for the engine is part of the clip. rear end is @...
i tried looking up wood finnish and got no matches. what other captions might get desired info?
i don't have the wood yet, but was looking down the road closer to being able to drive the truck, and was woundering about the best way to...
i saw a truck at a show and the gauges where from a (zig mobile) gmc school bus. that where same a 47- 53 but 12 volt. he said he picked then up...
Being up here in Canada, all the good deals seam to far away down south. I have been spending way to much time looking on epay at trucks, more for...
the hole are on the front of the rear fender, but not where the running board goes.they are on the side parallel to the wheel,90 degress to the...
both my rear fendees have what look like factory holes, i don't know what they are for. can anyone enlighten me? on the lower left side there are...
SUCCESS! i went to a freinds who live in town with high speed internet, but stil had problems to load to cp so used jon's( sloromon ) advise and...
Separate names with a comma.