I have a question for the experts. I have a newly rebuilt 235 in my 1959 Chevrolet truck. I have only put a couple hundred miles on it since the...
Getting close to finishing my complete frame off nut and bolt restoration of my 59 Apache Fleetside and thought I would post some new pictures of...
I am converting my 1959 12 volt Chevrolet truck with 235 from generator to alternator. I am using all the original gauges and want to make sure...
I have the original front fenders drivers and passenger side off of my 1959 Chevrolet Apache Fleetside for sale. I am not sure what they are...
There are so many decisions to be made when restoring an old truck it is sometimes hard to decide what is the best option and most cost effective....
Here's a couple of the cab. I am having all the sheet metal work done now. New cab corners inner and outer, front part of the floor pan both...
Went with the KBS rust seal satin black two coats over sandblasted bare metal. I wasn't able to do it all in the same day so I followed the techs...
Decided to go with KBS coatings they have been very helpful in answering all my questions. I have talked with some old timers who have been...
Guess I'll respond to my on thread since no one else has. Inline tube is a good vendor to get brake and fuel lines from very helpful and...
I am in the middle of a frame off restoration of my 59 truck. The cab and body are at the restorer and I am doing the frame (KBS coatings) and...
I am about to coat the frame on my 1959 Chevrolet Apache Fleetside. I am considering powder coating but wanted to see what others have had good...
Hi and Happy New Year to everyone!! I was wondering what the best bed wood material and finish would be (durabe and long lasting) for my 59...
I am starting a complete restoration of my 1959 Chevy apache fleetside short bed. I am removing the 235 engine and 3 speed transmission to rebuild...
It has been a while since I have been on here. I have a 1959 Chevrolet fleetside apache 3 speed 235 engine. The taillights suddenly quit working....
Four bolts hold the rocker box cover on for a 235, two located on each side. Two bolts hold the rocker box cover on for a 216 located on the top.
Not sure were else it could be leaking but I will clean it up and take another look. Dont think it was seeping until I switched to synthetic....
It seems to just be seeping out slowly along the edges of the gasket not everywhere just in a couple of areas. The front left side facing the...
Is it normal for the cylinder head on a 235 engine to weep/leak oil? It is not leaking bad just notice it around the head in a couple of areas...
Look on fleabay prolly have to by a junk carb and get these parts off of it. Do you have a Carter or Rottenchester? Dont think you can find these...
Separate names with a comma.