Thanks Larry, I'll check that one out for sure. Looks like a good value. Ron
Rob, hows it going? No V-8 yet.........lots of prep work involved before the motor install. I am about to fill in the holes in the firewall, and...
Not much in the way of accessories........I am putting in a Flaming River tilt column, going to a 12 volt, and yes, I am putting in a sm 350. But...
Has anyone used the direct replacement wiring harness form the store? Looking at buying one for my 50. Never have done a complete wiring job...
GRILL PC'S needed PM sent for these
Again, a wealth of good information! Nate, I thank you for your input........these radiators look like they're built pretty stout, so no skimping...
Thanks for the input.......This radiator is in good condition EXCEPT it has 2 bullet holes in it! I will take it to a repair shop and get an...
Is there any particular radiator for a V-8 swap? I am putting a sm350 in my 50 p/u, and I was told that the stock radiator was not sufficient. Is...
pm sent to you
I do not need this assembly anymore........make me an offer and I can send you pics. Thanks, Ron
I have a stock 216, with starter, generator, carb and air cleaner, complete front end with brakes and spindles and tie rods, torque tube, 3...
Thanks, I will post some pics throughout my build. This is my first time doing this, so I'm sure there will be ALOT of trial and error. Pulling...
Its been rebuilt, and it has low miles, they are very stout tranny's, and I got it for a very good price. I think with the right gearing, it...
I am pulling the stock original 216, 3speed trans, stock rear end, and steering column with the 3 on the tree assembly this weekend. They are...
I went with the 5" 4 3/4 pattern because of the rim availability. More choices with this setup, as you can use almost any Chevy rear end, rims, etc.
Now thats a very nice, clean set up. I wonder if you can use this in conjunction with a power steering unit? I located an already installed power...
Thanks. Sounds like a good set up.
What would you do differently? I want to retain the stock axle, is there any other way to get these things to handle good at speeds of 65mph?...
Will a power steering box from a 50's chevy like the 605 style fit, bolt up, or can it be converted to work with my 50? Thanks. Ron
This would be a great way to go, which I am looking into now. I already have the proper width rear end, but if I can find a smokin deal on a...
Separate names with a comma.
