Bill are you refering to the rod that goes from the pedal to the booster or the rod from the booster to the master cyclinder?...
federale would this trick still work if my master cyclinder is mounted on the frame lower than the bleeders? Thanks
Just completed the install of CPP front disc brakes with booster on my "54" 3100 everything is located in the original location on the frame. I...
Blueflame as I mentioned in my post I went with the disc. upfront but all I did to replace all my lines was used the old lines to make a pattern...
I installed front disc. Brakes on my “54” truck with a new master cylinder and booster from CPP and now I am having trouble getting a good peddle....
Thanks guys for the info this was driving me crazy I even looked in my assembly manual but missed the part in the diagram. This site is awsome I...
After removing the bed from my 54 I noticed this bracket on the left side of the bed but there is not one on the right side does anyone know what...
If I decide to go this route will the fuel run through the electric pump without it being on when it is not needed? So the object would be instead...
When I bought my 54 pickup with stock 235 the PO had added an electric fuel pump and bipassed the original pump, he left the old fuel pump in the...
Looking for working high and low note horns for "54" 3100. Let me know if you have em (Texas)
What the %^$% happened, I replaced the original 6v fuel gauge with a new 12 volt fuel gauge hooked everything up the same and when I hooked up the...
I really appreciate all the advice sometimes when trying to reach a conclusion you don't think about all the solutions that's what makes this site...
Wow make up mirror, nail polish hope the guys in the shop don't catch me with all of this might be hard to explain. Thanks guys for all the advice...
Need to replace my dead fuel gauge in the cluster my question is short of loosing 50 LBS and becoming a contortionist how the heck do you get up...
Thanks for the info Ken, my truck has 15" rims, 6 lug and also has the clips for the center hub cap I have been talking to the guys at Stockton...
What was the original size wheel for the "54" 3100 series truck? 15", 16", bolt pattern, tubeless, width? My truck has 15" wheels with the clips...
Gas Gauge Well after using all the advice and techniques given to me on this site I still have a gas gauge needle that is buried past empty. I...
Gas Gauge Pulled the sending unit out of the tank and it seems to check ok with the OHM meter, have power to the gauge from the switch so now I...
I have Yankee Model 960 add on turn signals on my 54 everything works with the exception of the indicator light on the turn signal assembly. This...
Looks like the one on my truck I wish I had the brackets that go back to the front of the truck mine where missing [ATTACH][/ATTACH]
Separate names with a comma.
