I have a 1950 3100 I am putting a T5 in I am having an issue with the alignment the dowels look to be 3/8 inch dia. Does anyone know if they...
I am getting ready to put a 10 spline input shaft in my T5 My present transmission is a SM 420 which is giving me trouble The 84 Jeep input...
I have a 235 with 500 miles on the rebuild of bottom end and 300 miles on top end rebuild. New pistons the works, the rings are Crome. Break in...
I have a 1954 head and a 1959 block and I have read that you need to drill a center head bolt with a 1/16 in hole to get the oil to the rockers....
I have one of the voltage reducing resistors for the 6 volt heater motor But it gets way to hot. So I ordered a 12 volt fan motor but in my 6...
Does anyone know where I can find the insert fasteners with the rubber insert for the 1950 chevy truck vacuum wiper motor smm 412 2 it requires 2...
can u wire a fuel gage backwards? Or will it burn up I wired the gage the way i thought it was before the only differance is i converted to...
Is there a differ on the wiring of amp gage when converting to 12 v which is in and which is the out post on 1950 truck gauge. Thanks for...
I recently bought new rocker shafts and the oil holes are smaller. The placement is the same but the new one has smaller hole. Old holes are...
Can someone please tell me the proper tdc on my 235 flywheel. It has the bb installed and it has a triangle stamped in it approx 1 1/2inches away...
Does any one know if the bakalite insert and the spring are required in the grease cup and if so does anyone know where I can get them. Thanks for...
I have a 1950 1/2 ton and have rebuilt the steering box After assembly the parts were centered on worm gear and assembled after putting...
Having trouble finding proper hose for my radiator I have a 1954 head on a 1959 block. Using conversion water pump and 6 cyl radiator any help...
Having trouble removing the vent glass on my 51 door. I have new glass so if it broke it would not be a problem but is there a better way to...
I have tires LT 215/85R 16 Tires and am looking for the proper inner tube size anyone know the proper size. Thanks for any help.
My truck has some 6.50-16 bias tires and are in need of replacement I have the origianal 6 bolt rims Someone has suggested replaceing them...
The bushing in my 1950 3100 rear end which has a 5/8 bolt in it that , attaches my axle to the springs looks to be rubber. Does anyone know...
when converting from 6 volt system to 12 volt system why is the ingition ballast resistor required. ( or is it not) on chevy truck 1950...
Am installing a 1959 235 in a 1950 pickup 3100 the front motor mount plate has been switched and the mount fits but the front mount oil shield...
I have a copper head gasket for my 235 and i want to know if it matters which way is up when installing It seems to fit either way and does...
Separate names with a comma.