Everyone had great feedback, at this point, all bleeders are up as suggested, I recently GRAVETY BLED front and back. This was a great help,...
My set has self adjusters only. I don't know the doner for the rear end however it is a GM. I did not build the truck so I'm at a loss for the...
I have a 47 with a 1994 S-10 Front clip (disk front, drum rear). The truck has a GEO Metro Booster and Master Cylinder with all new brake...
Thanks Nate and All who replied. I finally got the pan off, driving a putty knife between the pan and trans housing. I went through two putty...
I know this is going to seem like a dumb question but here goes: I have been fighting a transmission pan leak for the last 6 months. The trans...
The engine (350) in my 47 setting on an S-10 chassis is on more of an angle than I would like. The front of the engine is higher than the rear....
Hi Evan, thanks for the reply to my suspension delima. I did as you suggested and checked out Rock Auto, they have everything I need to rebuild...
Great looking truck, really like the two tone. What type of Air Suspension did you install and where did you purchase? Thanks Ron
Thanks for all the help I will check out all the recommendations. I know one thing I have to get the drivers side lower control arm, my current...
Hi Folks, I need your help resolving a Front Suspension problem with my 47 setting on a 1994 S-10 chassis. I do not know the history of the truck...
Header Help Thanks Evan for the pictures they always help. I hope to avoid making this modification with my small block but if necessary I...
Thanks Nate, sounds like a different approach. The clearance between the engine heads and the steering shaft is going to make this interesting,...
Header Help Thanks for your help. I just looked up Carshopinc on the net and found the headers you folks were talking about. Should I assume...
Hi Folks, I need you help once again. My 47 sets on a S-10 Chassis with 305 small block engine. The current 305 has stock exhaust manifold and...
Ken, thanks for the pictures they are very helpful. Ron
Thanks for the replies to my headliner issues. I only found one company making a plastic insert, the company I called was Rod Door's. Apparently...
Trying to complete my interior and it's time for the headliner and the cab seal. Need your feedback on headliners (stock and custom) what works...
Front Door Glass Problems Hi Folks, Just received the weather strip channel which I ordered from "Mother Trucker Trucks" OUTSTANDING...
47 Door Glass Problem Good Morning, Great, I just sent you a PM with details. Ron
Hey DeadZoneTruckin, again thanks for the picture of the cut away door it sure helps. I have found the problem and it's not good. The front...
Separate names with a comma.