Heater "warmer" knob shaft bushing

Discussion in '1947-1954' started by calebroberts, Dec 14, 2006.

  1. calebroberts

    calebroberts Member

    Joined:
    May 23, 2006
    Messages:
    21
    Location:
    Lyons
    Hey everyone,

    I need to replace the rubber bushing in the bracket that supports the temperature control shaft at the bottom edge of the dash. Does anyone know if there are replacements available for this?

    I've tried adapting a speedo cable thru-the-firewall rubber bushing but it's really too big.

    thanks,
    Caleb
     
  2. omega7979

    omega7979 Member

    Joined:
    Jan 20, 2006
    Messages:
    75
    Location:
    chicopee Massachusetts
    bought some rubber grommets at home depot for running a 1/8" wire thru a firewall on a race car......im sure they have them at lowes too or even ace hardware........they usually have a good selection

    Good Luck
    Leon
     
  3. 54chevtruck

    54chevtruck Member

    Joined:
    Nov 16, 2006
    Messages:
    327
    Location:
    West Chester,PA
    Ace or True Value hardware stores around here have cabinets with various grommets in them. Just match up to what you need.
     

Share This Page