Pins (J1115) for pulling transmission

[put-put]

Does anyone have a source or replacement for these pins used in the top 2 bolts holes of the trans as guides for pulling the transmission?

thanks, PUT_PUT

 

[ol' chebby]

Cut the heads off of longer bolts.

 

[vwnate1]

Tranny Guide Pins

What Russ said ! .

I always loose them after the job so each time I do a clutch , Imake up a new set .

Just take one tranny to bell housing bolt to the Hwe. Store and match it up , cut the head off with a hacksaw and chamfer the sharp edge a bit so the tranny slips right over it ~

This is one of those Journeyman tricks that ensures long clutch life .

 

[put-put]

excellent, thanks

 

[Bill Hanlon]

cut the head off with a hacksaw and chamfer the sharp edge a bit so the tranny slips right over it ~

What Nate said + cut a slot in the non-threaded end so you can use a screwdriver to back the pin out instead of trying to back it out with your greasy fingers.

 

[vwnate1]

Fwiw ;

If you're doing clutch work , you have no business having greasy/oily fingers ! .