I have a 4spd sm420 $100 a good running 235 complete from carb to pan gen and starter foot start throttle linkage, a 235 and a v8 bell housing...
I did not purchase the kit from any suppliers but rather fabricated my own and used the instructions online from Brothers, CPP, and ran into the...
You can plug the oil filler tube with a freeze plug, not sure about the vent tube. If you do not like the intake with the filler tube, I would be...
I boxed my frame and used different engine side mount than what you are using however my tranny mount was a square tube type and it located the...
The only difference in a 55-56 fender from a 57 is a 57 has a hole for the grill. The grills are different and you could even use gmc fenders as...
http://www.tagworld.com/AZMark Check out this site
Nice pic of the column, I haven't installed my column with my m11 yet and I can see how a shorter column may cause some interference with...
I thought the preferred method was to have the end of the column close to the fire wall, about an inch, in order to reduce the angle on the joints...
That sure is a sharp truck!:cool:
Not sure about the repop chrome, nothings fits quite like original equipment. I would say it is a matter of personal opinion and what level of...
The mustang front end is intended to lower your truck and your lower control arms should be paralell to the ground. You don't have the correct...
I believe that the track width is wider on the front suspension of 67 and up chevy trucks than your 59. So if you did make it work, the tires...
Ididit, flamming River are a few that sell aftermarket columns with GM wiring, basically a gm style column. They come in several different...
Any gm column will work but you need to take in consideration that if you use a superride, you will have rack and pinion steering and you need to...
Separate names with a comma.
