mofoa
Member
Mine were 39 an 13 gave me a 3.00. I'm going to try it before I spend money on something else. I was told 3.50 work really well with the 700r4
Which vehicle did it come out of?
-
We have upgraded our forum software! See here for details.
Mofoa's 54
- Thread starter mofoa
- Start date
Which vehicle did it come out of?
mofoa
Member
In this shot, I can't tell whether or not the seal started to come out while I removed the yoke, or if it's been this way for a while--you can see the seal and a bunch of crud in the gap between the seal and housing.
Removed the seal and bearing
Cleaning up the bearing
Removed the seal and bearing
Cleaning up the bearing
Last edited:
My 9" with 3.00 gears came out of a 71 Grand Torino. Don't know where to get the 3.50. Anyways make sure the rear is close to stock in width. My rear vacuum plate to vacuum plate is 51" which makes it hard to get any kind of offset. I think stock would be around 55" vacuum plate to vacuum plate. Something to think about.
