Recent Content by BamaJohn66

  1. BamaJohn66
    Post

    Jeep door checks in 66 c10

    I have the rear door checks installed on my 66 for over 12 years now and they work great, they came off the shoebox square Cherokees , mine didn't...
    Post by: BamaJohn66, Jun 5, 2014 in forum: 1960-1966
  2. BamaJohn66
    Post

    Installing a 60/40 seat help

    Thanks for the help guys I just had to think a little outside the circle again,sometimes I forget what an upgrade is all about,i pulled the rear...
    Post by: BamaJohn66, Mar 27, 2005 in forum: 1960-1966
  3. BamaJohn66
    Post

    seats

    Thanks for the reply,Last week I found a 60/40 seat out of a 95 Chevy P/u and then took the headrests out of the rear seat and re-mounted them...
    Post by: BamaJohn66, Mar 27, 2005 in forum: 1960-1966
  4. BamaJohn66
    Post

    Installing a 60/40 seat help

    my measurements with the seat sitting on the floor is around 5 1/2 inches from floor to bottom of seat cushion (or top of rail)Im having all kinds...
    Post by: BamaJohn66, Mar 22, 2005 in forum: 1960-1966
  5. BamaJohn66
    Post

    Leaking Rear main on 350

    I dont know your answer but I would find a engine building shop online or in person and ask them the question. I bet your not the only person...
    Post by: BamaJohn66, Mar 20, 2005 in forum: 1960-1966
  6. BamaJohn66
    Thread

    Installing a 60/40 seat help

    I have picked up a 60/40 seat from a 95 chevy p/u, it appears the seat is going to sit too high into my back window,has anyone installed one using...
    Thread by: BamaJohn66, Mar 20, 2005, 4 replies, in forum: 1960-1966
  7. BamaJohn66
    Post

    1965 C-20 Front Brakes

    Gte out your tape measure and go junk yarding,those parts pullers if not complete idiots have a world of knowledge as whats the same all you...
    Post by: BamaJohn66, Mar 16, 2005 in forum: 1960-1966
  8. BamaJohn66
    Post

    65 gear rearend

    Im not following your numbers you listed for your rearend ID the number you need will be on the front leading edge of the passengers side of the...
    Post by: BamaJohn66, Mar 16, 2005 in forum: 1960-1966
  9. BamaJohn66
    Post

    Instrument Panel

    Lets not forget the speedo cable ;-)
    Post by: BamaJohn66, Mar 16, 2005 in forum: 1960-1966
  10. BamaJohn66
    Post

    Help ID engine

    If you look on the flat pad on the block right behind the alternator (pass side)you will find a series of numbers and letters these numbers will...
    Post by: BamaJohn66, Mar 16, 2005 in forum: 1960-1966
  11. BamaJohn66
    Post

    62 C10 Guage Cluster

    I could be wrong but I think the wiring harness is different,but Im closer to right by saying call someone at chevy duty for direction and parts
    Post by: BamaJohn66, Mar 16, 2005 in forum: 1960-1966
  12. BamaJohn66
    Post

    Installing a 700R4

    Thanks for the site,I had always wondered how to figure that kind of stuff out,I got the information I needed and since california is just a...
    Post by: BamaJohn66, Mar 16, 2005 in forum: 1960-1966
  13. BamaJohn66
    Thread

    seats

    I am looking for nice replacement seats to go into my 66 big window truck,I prefer bucket console setups that dont extend into the back window...
    Thread by: BamaJohn66, Mar 15, 2005, 2 replies, in forum: 1960-1966