RE:axle swap The rear end swap is definatly the easiest. You can take any of the coil rear ends out of Chevy trucks up to 71-2 (I think the last...
There is a product called Rass-O-Nil that works great. Its mainly for rustproofing raw metal that needs to be painted and look good. You can...
I purchased it from www.usbody.com. I went with the cowl since mine is more of a hot rod than a restoration. They offer them in both stock, 2"...
Ok guys. I feel kinda foolish since I spend most of my time answering these kinda questions. I purchased a hood bumper set 10 piece. It came...
I have had those problems with Harmons as well. Doing a resto this winter and looking for good quality rubber as well for my 65 sb ss. My filler...
Lokkar makes a floor mounted shifter for automatics. Nice billit alluminum pieces only, so kinda spendy but not to bad.
One common problem on these trucks is when they get old they have intermittent electrical problems which are usally fixed by trying this. There...
Before you start replacing parts aka shotgun trouble shooting try this. Next time it starts acting up, remove the connector off the back of the...
0-30 ohms. I seen this problem once one a car that the people always kept it at about half, or less. After years the carbon on the strip gets...
Another easy way to fix this problem is to look at the switch itself. there is a brass plate that connects 3 pins on the bottom of the switch or...
Probably the cheapest way to go is to use a Lock Right by Power Trax. Detroit copied them with thier ez locker. Both easy units to install as...
The cheap way to go is get one from the junk yard. Take a good measurment and one piece of advice, measure your u-joint as well. I found one out...
You are in luck. First time here at this msg board and already I can help. It has been a few years but I found my slip. this is for a 65...
Separate names with a comma.
