yeah I like those and tried a set but no leg room unless your 5'7 or shorter I'm 5'9 and my legs would tighten up after long drives ended up...
Yup same place I got mine :)
I'm looking for the Y-pipe that connects from the ramhorn manifolds for a 350 CID engine, any ideas where I can get one. maybe a wrecker? The...
ran like a top I sold though it was a 235
will the aftermarket perches for a 63 fit this frame:confused:
any suggestions for installation of v8 perches on a 62 frame with no holes in frame previous engine was a 6 cyl also goin with th350 from a 3 on...
Just about got all my disc upgrade kit installed I've run into a problem lineing up the brass banjo end there is a bolt that goes through it with...
Thanks 66Kustom the guys at Stockton Wheel say they can take my original wheel and remove the face and weld it to a disc compatible wheel. He...
Thanks Val Where ya at in Sac. I'm in Elk Grove:)
Well I finally got my kit for upgrading from drum to disc after gettin the rotor and caliper installed my wheels don't fit they are oem 6 lug 15x8...
what about products like rustoleum spray paint or por-15 I was thinkin about using either or, only after hittin the parts with a wire brush :cool:
Separate names with a comma.
