The last set of wires I purchased for the '51 were for a late model Jeep Cherokee with a 4.0 inline 6. They fit very nicely, but two of the spark...
Wolfgang- I am assuming that you are using the original accessory AC canister type oil filter, or something similar. The upper inlet of the...
I have a front axle for a 55-57 1/2 ton available. It includes the shock mounts. Free for the taking, just come pick it up in Rolla, MO.
Its been a while since I've replied to anyone, but... Yes, the torque tube is the same. I made the 3 speed to 4 speed swap a few years ago. The...
Thanks for asking, Nate! I did get it sorted out. I wound up finding a second 2010S to match. The manifold is on and everything is fine...mostly....
First, make sure the torque tube is clean of grease and dirt, especially where it necks down at the front. Unscrew the ring at the rear of the...
Bill- It sounds like you have a handle on it. You may need to trim some of the outside of the cable, as long as the overall length of the cable...
To refresh my memory... a 3600 is a 3/4 ton, right? If that is the case, a 3 speed column shift was standard, with the 4 speed as a factory...
Actually, the additional mount is at the very front, under the radiator. The shop manual refers to all of them as mounts, even though only 3 or 4...
Keep in mind that the cab mounts were changed in 1949. 47 & 48 had four mounts, where 49-55 had five mounts.
No pictures available yet, but here are a few answers... 1) There is a difference in the placement of the throttle bell crank on the block...
I don't know. Plenty of people shove a Chevrolet engine in a brand "F" vehicle. Seems like a fitting twist...
Thanks Everybody for the kind words. @1951chevy1ton-I can't take credit for anything more than writing a check for the manifold. On the...
After many years of wanting one, last January I ordered an Offenhauser dual carb intake. I messed around a bit trying to get matched carbs, but...
Separate names with a comma.
