Recent content by trucktony

Thanks Nerfherder 78 The ones on your picture are probably ford mirrors related I found those but wanted something that would follow the contours of the plastic moldings that are one the door a little more I will probably end up making them myself from some ferro tubbing and with the ford...

These are the Photo's of the mounts

Hello Can anyone help me out on finding the right aftermarket door mirrors for my 1977 c20 truck The truck is in such a good condition I hate to drill the doors for just any mirror And because there are already mounts on the doors I was hoping someone could tell me which mirror fit these mounts...

Hello At last I could buy my dream truck It's a 1958 chevrolet Cameo has a Hydramatic automatic 4 speed I want to rebuild the engine and transmission Can somebody here tell me whats the best way to take the engine out? because of the flywheel gasket on the torus I would think it's best to take...

I am working on a 1958 chevrolet v8 283 with hydramatic transmission starter on the righthand side We bought it without a starter motor I can not find one desperate in need of a photo do you have one or do you know anyone how can get me one? I am searching the net and all kinds of manuals ,but...

Hello there I bought a set of panel truck front seats But they seem from another year as mine 47-54 Can anyone identify these I am very glad with my purchase but realy want to know where they original came from Say's body by fisher on the decall first thought they were from a 39-46 panel but...

Thanks lakeroadster This is real handy info I will try to figure what's what and make this work thanks again

Can anyone tell me what's the difference between the 1958 and 1964 slongbed stepsides? I know the wheelbase is different and I would replace the fenderwells a bit forward proberbly. But how much and what are the pitfalls? I can trade a 1964 stepside for a 1964 fleetside bed and want to put it...

Your absolutly right A flatbed it is came across the fleetside bed and bought it before I could say No Always wanted a flatbed fleetside is going to be sold Thanks for the advise Gone be searching for some cheap 2x4's and make a flatbed...

problem I ones had was that the rear bulbs are under continues voltage + and then to make them lightup there is ground edit to the bulbs. At least that's how I figured it out at the turnsignal cup on the steering column so you must have your tester light on with everything off (except ignition...

this will be a cheapo conversion till something good shows up That's why I don't want to do to much on the bed I might make someone else happy with the 64 bed Now it's just laying around picking up rust. If I use it it will be better off And as I said " I like to be different" Some good things...

made a template from the driversside inside sunvisor hole center from hole is ABOUT measured from the weldingseam as in the accessorie booklet horizontaly 45 mm from the round curve of the window straight upwards 55,3 mm up via the curve of the window measured from the seam 30mm straight...

1959 passenger car and truck accessories installation refference manual At page 269 it shows a template to be used for guidens to drill the holes partnumber 987995 I hope the scan comes forward on this reply Or maybe someone else can help you out or get the accessories booklet

My 1958 fleetside long bed was to far gone to repair Used it for my rear fender wells of my 58 panel truck Now I can buy me a 1964 fleetside long bed lenght is about the same (98") Only the wheel base is different (127"1964) (123.25"1958) Rear overhung is 47,48"(64) 53,12"(58) But if I...

Found some tailgate emblems for the suburban carrier size 14"x 2" NEW must be repro's no partnumber cast in Had one offer for 245 dollars each shipping and handling will take awhile Cause I will have to send them from europe