Thanks Larry, I'll check that one out for sure. Looks like a good value. Ron
Rob, hows it going? No V-8 yet.........lots of prep work involved before the motor install. I am about to fill in the holes in the firewall, and...
Not much in the way of accessories........I am putting in a Flaming River tilt column, going to a 12 volt, and yes, I am putting in a sm 350. But...
Has anyone used the direct replacement wiring harness form the store? Looking at buying one for my 50. Never have done a complete wiring job...
GRILL PC'S needed PM sent for these
Again, a wealth of good information! Nate, I thank you for your input........these radiators look like they're built pretty stout, so no skimping...
Thanks for the input.......This radiator is in good condition EXCEPT it has 2 bullet holes in it! I will take it to a repair shop and get an...
Is there any particular radiator for a V-8 swap? I am putting a sm350 in my 50 p/u, and I was told that the stock radiator was not sufficient. Is...
pm sent to you
I do not need this assembly anymore........make me an offer and I can send you pics. Thanks, Ron
I have a stock 216, with starter, generator, carb and air cleaner, complete front end with brakes and spindles and tie rods, torque tube, 3...
Thanks, I will post some pics throughout my build. This is my first time doing this, so I'm sure there will be ALOT of trial and error. Pulling...
Separate names with a comma.
