Check your rollers. If they are cracked/gummed up they will slow even a new window motor. If they are just dirty, clean them and lube it with...
Just the radiator support, fenders/hood are the same.
Made me realize I haven't taken a decent picture of my truck since I swapped the diesel in (almost 3 years ago).
A multimeter (voltmeter) is very handy in tracking down where you're losing power for the headlights, and many other electrical problems you may...
How did the tape do when installing the vent window? One problem I've had every time I pull/install that has been scratching the paint. And how...
Got this from a fullsize gm 4x4 forum I look at. Most people there prefer manual hubs to auto because you KNOW your hubs are locked (which seems...
They were probably thinking of a short bed silverado pickup. The only major difference in K5 frames was from '76 to '77 (may want to double check...
I think the best way to achieve that would be to cut the a/c box in the engine bay just past the heater core hoses, then fabricate some sort of...
Standard heater does not have the 4 dash vents like a/c, just the 2 defrost by the windshield and the vent below the dash over the trans tunnel....
I agree. If you can find an '88 or later 700r4, I've heard they are a little stronger than the earlier versions. You may also want to check out...
I went from non-a/c to a/c when I did my engine swap. It was fairly easy to work on without the fender and hood in the way. I lined up the outer...
Not in CA. Requirements are stricter than Federal Smog and use a computer controlled carb. A headache I'm glad I'm rid of.
Well, considering it is still legal to drive a car without a seatbelt if it was not equipped from the factory, I don't think they will be able to...
You can also adjust the shims between the cab and the fender. If you're reusing the ones that came on the truck, they may or may not line up the...
I did the reverse because I prefer the '85-'88 Silverado look over anything else; basically all you need is the headlight connectors, core...
Dont remember exactly where, but you stick the end of a paper clip into one of the slots and turn the knob.
I think the only difference in frames between those years was the front horns where the bumper mounts. '81-'91 are cut at an angle for the...
That's part of the cruise control system. Its a vacuum actuator that holds the throttle open when the cruise control is active. My diesel parts...
You are correct about C and K series. I would check the VIN (http://www.lmctruck.com/icatalog/cc/full.aspx?Page=12). Could be that someone at...
I'm not sure what would be best for your setup, but generally lower gears (like 4.10's or 4.56's) would be better for towing, but they aren't...
Separate names with a comma.
