I've never tried it. The kit I describe has the Distributor side wires at a 90 degree angle except for the coil.
Plug wires can be a problem for most people because you get them in a kit. The Distributor ends are not on them and you cut them to length. The...
Since when HEI came out, it came out with the module built in to the Distributor, and the coil totally redesigned in shape (square), we have to...
Be sure you have the right starter. Also, the spring that helps the starter drive engage the flywheel is an important part of the system. It was...
Yeah, NOT a good replacement. The stock coil without the Ballast Resistor built in is 1.5 ohms and that is too much. The MSD 8202 is really the...
The reluctor sits down almost on the base. I like to pull it up a smidge just so the screw underneath it doesnt rub. The ground cable just...
It takes me longer than 15 minutes of machining, but the result is better than Pertronix and much better than stock. Using your own Tall Cap...
I'll do my best!
yeah, narrow band has its limitations, but it is far more accurate than the shop manual telling you to turn the mixture screw all the way in, then...
Nice! I wish everyday I still had my Dad, so cherish those moments. Good for you!
Same threads Bill. Narrow band is just so antiquated, nobody lists it anymore. But it is the one you need for using a meter to read it. They are...
The Multimeter is connected straight off the O2 sensor. Red lead on the single wire that comes out of the sensor and Black lead on ground. Measure...
[MEDIA] The one I chose was narrow band because I didn't want to use a gauge. The above shows how to use your multimeter to do that. Bill, I...
I hope birthdays are a time for celebration for you! If not, DISREGARD!! :)
No idea what that even is! I have never owned a vehicle without stock intake/exhaust. I do know that HEI is better no matter what the carb or...
The HEI module that is found on board most common HEI distributors is not part of the our original stock Distributor so we need a place to put the...
The HEI System I make for our engines runs great with the E3 .040 gap. The Pertronix would be the same way, and the st0ck system also would be...
There is another avenue. It is controversial to those who do not like to test these things, rather go with what has worked for them all their...
No problem removing the oil pan on a pickup. I have done it many times. Not that I am happy about it, but it is not difficult to do. You should...
I wouldn't use stainless for grade 8 applications, but they make a few different alloys of stainless that is harder than others. Haven't...
Separate names with a comma.
