Truck and car shop, page 93, one for idiot light, one for gauges... http://www.scribd.com/fullscreen/105622812?access_key=key-25nhdrsz2gz3h8aoa7qx
[IMG] Here ya go...
cool....whats next...?:cool:
Dave it would have been easier to grind the rivets heads off then smack the BJ with a hammer and punch it would have been about 5 minutes each...
Here`s a short list of a known truck today... 1963 Chevy C10 unknown mileage Motor 1997 LS1 block Stock Crank 3.905 Diamond pistons...
Unless you've made serious suspension mods to your truck, it will not hook up, there are several low 11 high 10 trucks that have no frame mods...
Dave, is it easier to get 10/30 weight, probably a better choice... for the rear axle 90 weight, do you know if you have a posi in the rear axle..?
I`m also against taking out the drip rail, use this and all your troubles gone away http://www.evercoat.com/productDetail.aspx?pID=257
This should help
You'll need a set of the factory lower v8 mounts, wrecking yard or some one's donor truck, '63 to '66 use the rear holes in the crossmember, all...
My booster is `67 caprice if I remember, master is 67 chevy truck drum/drum. booster is bolted right to the fire wall, your margin of error will...
Any `73 to 87 C 10, grab everything, booster, master, prop valve, spindles, caliphers, brackets, hubs. you may have to buy new rotors, so as to...
Normally we use the weight of the vehicle to compress the springs when removing the springs, so now you`ll have to rent or buy a spring...
Bob you did great on that....!
The 63-66 a-arms can also be used with any other spindle (71-72 or 73-87) with a simple ball joint change. The upper and lower ball joints and...
David the `65 model used a 30 ohm gauge and sender, to test the gauge you`ll need a small cheap volt ohm testor, with no more that 1.5 volts to...
If its cast iron , it's a power glide, they never made a cast iron th350.
Go here post # 12. https://talk.classicparts.com/showthread.php?t=17679 we were discussing shock angles.
One pic from the rear, you cannot see the tank at 10/15 foot back at 12 inches off the ground...so far I'm pleased with the outcome.
Separate names with a comma.
