Morning Guys !! I could use a little help with a contest over at Texeco I have my 37 Ford entered in. Actually, I could ue your VOTE !! The...
Congrats on your excellent taste !! :) A word of advice to both new oweners in this thread. Three words. Factory Service Manual !!...
Look at Clifford Performance for some ideas......
Two thumbs UP !! Very nice indeed !!!
In a word ?? YES ! Everything is interchangeable between the C10 and C20's on the body. dv
One more thing !!! Rather than just "bleeding" REPLACE all the old fluid !! Keep bleeding and adding until clean brake fluid comes out of each...
Here is a way of doing the same thing in about 10 minutes. Jumper at the headlight switch... http://www.persh.org/pickup/Headlights.htm...
On our trucks it is Left Rear, Right Rear, Right Front, Left Front... dv
Axles front and rear, ball joints, control arms and spindles are all heavier to withstand more weight. don't think you will have much luck...
How are the kick panels right above that rusted out floor ? Check the roof around the drip rail for rot too... No body makes a replacement...
Welcome to the forum.. I like it all, except the late model bed part. Just my personal opinion, if you like it,,, go for it !!! Suicide doors...
Except for the track bar and shock mounts the frames are the same in the rear. dv
The front reservoir goes to the front brakes, the rear, goes to the rear brakes. There should also be a proportioning valve very close to the...
True. However those tanks are protected by placing them near the center of the vehicle and well inside crush zones. dv
drool !!!!!! ;)
If the tank is not leaking because of the rust, it can be cleaned and coated with a sealer. Eastwood carries a product to do both. Probably less...
There is a sender for the temp light on the motor. On V8's it's located on the left front of the intake manifold. ( not sure about the inline...
Yer KILLIN me !!! lol !!! I can't open a can of dog food without some issues !!! Yes, the roof skin can be replaced by someone who is...
Tips to reading block casting numbers. As stated before the casting number you need is located onthe blocks' bell housing flange just below the...
If you don't have them already, pick up a set of foam pads for the polisher.. I ONLY use Adam's pads and products for machine polishing. You...
Separate names with a comma.
