Thanks Thanks Evan. It came with the truck. One place said it was a 69 posi and one off the casting number said 66. I'll take all parts to be...
Good evening all I know this has been talked about but I can't find it. I have a rear end to ID W Casting # 3856525...
Watch it Zig Always wanted a gray truck with black fenders...and that's what is setting in tHe garage! Maybe it'll run to the fishing hole one...
Getting old ain't so bad Ya I have reached the age where something new hurts every morning not to mention the stuff that hurts all the...
3 on the 48 I took a 48 cab and put it on a 53 only because Nate said it would work. The 48 had the two mounts in the front and a single mount...
Thanks Nate Papy
Pto Jim Did you take the PTO off the trans where the Aggie Cover is? Might be a stupid question but how hard is it to get it off if it comes...
Good looking flat bed Good looking truck Bill. I like the flat bed. Enjoy the truck and retirement. I'll never get to retire, my redhead would...
Hang in there Zig. I am getting close to nine years and have not heard the motor run in the truck. Quality work takes a quality plan and quality...
Black Beauty Black Beauty is coal slag from Reed Mineral. That's what I have and am using. It's pretty safe no free silica you still need a...
Coal slag Nate is right on sand. Don't do it. Silicosis of the lungs is nothing to fool with. I used fine coal slag. It's hard,cuts rust, does...
Pic's Zig It was way to cold to hold the phone still...but...the fish were biting. No wonder my truck isn't done. I'll see ya in Ottawa. Papy
Small blaster I did my whole truck with a 40 lb pot sand blaster I bought from Harbor Freight for cheap. Took a while but you can do it. Start...
Zig It's in Septemeber I think. Usually hot and sunny and other than Good Guys in KC the best show around that I have found. Small town...
Never thought about putting an old spring back in. Guess I thought all of the oldies would be in the same shape as the ones I took out. I...
Replacement Zig It was on the list of things to do and I couldn't get grease to pump in without a lot of heat so I tore them down. All four...
Brakes and breaks Nate I replaced all the parts on the drag link and steering arm packing grease in and then made a mess with the grease gun....
Thanks Bill and Nate. This setup looks bullet proof if it has plenty of grease. I'll get it back together and start on the breaks. Thanks...
I purchased the rebuild kit for the steering/drag link. After three days I got the caps off cleaned everything up and greased the new cups and...
I learned to drive setting on my grandpa's lap out in the field or headed for our favorite fishing hole. I couldn't reach the pedals but I...
Separate names with a comma.
