The C60 is 1 1/2 or 2 ton. This is a big grain truck with a dump bed. I want to put it onto a 1/2 ton chassis.
I'm working on a '62 C10. I just found a nice '62 C60. The sheet metal is pretty nice. Does this stuff fit on the 1/2 ton? I didn't know if the...
I have a stupid question .... again. I'm woking on a '62. I am mocking up to install the heater. I bolted it on the firewall. So far so good. Now...
Yes I put those in. That is what the window channel is hanging on. They have got to go! In the street rods we use smaller pieces and just glue...
I'm not sure what the anti rattle strips are. I relined the devision bar channels (those are the ones right behind the vent window) and I...
I put the fuzzies in with the supplied clips not adhesive. It is the glass channel on the bottom of the window that is hitting. The window...
Lucky guy! When my stuff smokes it is usually wiring burning or the motor needs rings. My wife gives me a hard time all the time - - Without...
I just rebuilt all the door window fuzzies. Everything new. When I roll the windows up the glass mounting metal on the bottom hangs up on the...
Don't stop with the 4 speed. Go ahead and put the 5 or 6 speed in with OD. Then you can do some real cruising! Just my 2 cents worth...
I agree with the van column. That is the one to have. The prices on those is pretty high if you find one at a swap meet. The street rod guys like...
I don't have the switch. I was checking it right at the motor. Does this motor just have one winding and use a resistor in the switch or does it...
Maybe mine is just a single speed now --- Meaning one speed is broke.. Time for a new one. Thanks
Here is a link to the Blazer tank install on a later model frame. Hope it helps with a 60s frame. I didn't reuse the factory crossmembers. I made...
Couple of things I forgot about the truck... The motor is pushed back as far as possible because it is heavy. I am trying to keep the front...
Hi everyone. I'm new to this site. I thought I would do a little introduction. As you can see from all my recent posts I have a few ideas and...
I'm putting together a basket case 62. I will be using an aftermarket wiring harness since I have none of the original wiring. I have the single...
I have a buddy that runs a fiberglass shop. Their shop truck is a 65. Everything but the cab is fiberglass. He builds some of the best glass...
Vintage has just reintroduced an old school under dash unit called the Mark IV. It is a design from the late 60's early 70's. It is an under dash...
Want to save a few bucks on that one wire alternator. Check out the marine alternator parts at you local parts store. Where do you think those one...
It cost me a little over $200 to have my truck shaft done. I had new universals on it but they wouldn't use them. It had to be their big dollar...
Separate names with a comma.
