The folks that make the kits will most likely use existing pre-manufactured wheel bearings that fit other vehicles. Make sure to ask the kit's...
You could take the starter OUT, and run it over to the local parts store, Kragen, etc etc,, and have them check it out... Val
" is it possible to just sell the vin plate and title " Not "legally" in California, (Check with Florida DMV), and I suspect anywhere else !!...
If your truck has an automatic trans, the netural safety switch is located on the bottom of the steering column, upper side, inside the cab. Val
Hi Tex, As you already know, that's the voltage regulator. The only way that would effect "starting" is if the battery were dead.. It is part...
Battery !!! Charge the battery........
Your best option would be a replacement frame from a 64-66. EVERYTHING will bolt on, no problem. I would see about getting your frame...
https://talk.classicparts.com/photos/showphoto.php?photo=2098 Nice job Buddy !! That's my kind of motor !!!! Val
I don't know of any aftermarket pieces for panel trucks from the doors back. It would be easier to fabricate them than it would be to try and...
YES, the truck could be ordered with the 409 engine option !! Pretty rare in a pickup, but was common in the larger trucks ..... Val
Check that the thrust rod off the brake pedal is fully depressing inside the master cylinder. Mark the rod when fully depressed, then disconnect...
Gotta agree with what Kustom says... Unless you enjoy changing valve stem seals/guides !! ;) Val
Right back at Ya Pard !!
Form 73 through the 80's front crossmember swap is what you will be looking for. But be aware, you will most likely only save a few hundred...
This might seem a bit obvious but it bears repeating every so often. DO NOT cobble together steering and braking components !! Make sure those...
GM - Metalic Indigo Blue, 2001 and above. Sorry, don't have the paint code here.. [IMG] More pictures of the 37 in Member Galleries under...
Yes, the original auto shifter column will work with the TH350/400. But,, you have other options to get rid of that keyed tilt coumn. ( I hate...
On my first set I did use a dry graphite lube. They went on good, but then they would not stay in the UP position when driving ! Drove me NUTS...
I knew I had seen this before but lost track of the link. Anyway, Here it is.. Lots of good information and great pictures of the procedure....
I first made sure the rod was as straight as could be. Use the old roll the pool cue across the table thing.. Then, I rubbed the rod down with...
Separate names with a comma.
