how much fab do you feel like doing and how good are you at body work?
is a govloc not a posi and its a turd in box. that 383 is going to chew that axle up like mashed potato's in a croc pond. the swap it self...
67-72 are going to be the easiest to swap to, the frame at the cab is dead flat like yours is, 73+ has a step in the frame and the forward cab...
yes the wheels are incredibly retarded but that is top notch fab work. you want to see how to body swap, 4wd a 2wd or any other extreme fab that...
you do realise that a cj7 is about 20" shorter wheel base than the shortes chevy right? and the jeeps run the lightest weakest running gear...
yeah, thats why the next line is "2wd high hump is removable"
i dont know what is more wrong here? you are complaing about a "subscription" [to what i dont know] because of a 53 build that you didnt...
its like a th400 od.
the 67 will have the small bore bell houing so you will need a sm420. they switched to the 465 in 69 ish so if you find one besure to grab the...
its not that bad, you can either keep it all together and let it tilt way back, then jack the back side up as you lower the motor in the rest of...
vin decode. find the spid or build sheet.
you cant, it still sticks up some.
you will have to pull the flap that covers the hinge away and you will see a pivot and a bolt, remove the bolt.
chassis are the same for the most part, the steel maybe a bit thicker. the trailing arms are plated in a 3/4 and not in a 1/2 you could get...
you need to take the cover off and inspect everything. if the pinion bearing is toast odds are the rest are too, its only 50y/o......... once...
what parts?
there are a few things you can look at. like the mounting pads? are they straight or on an angle does it have a trac bar mount? is it a...
it depends on the quality of the paint and how often you feel like redoing it. they make good, sealing, long lasting flat paint that doesnt...
but remeber that its a car 10b and not a truck. measure the backlash and check the pattern BEFORE you disassemble it.
when you reinstalled the trans did you make sure to grease the throw out bearing shaft? did you adjust the linkage rod so that your clutch...
Separate names with a comma.
