Nate and Andy have been so helpful with their advice as my friends and I are installing new clutch parts on my 52 3/4 ton. But as you said, the...
Hey gang, My friends are coming up this weekend to help install all my new clutch parts, pressure plate, etc, and then re-install the trannie...
Hey gang, Anyone following my clutch questions the past month or so may remember that Nate gave me a play by play on how to take the...
Hey gang, Now I am taking the clutch out of my 52 3/4 ton -- and the disk and pressure plate are 10 3/4 inches. Called Classic Parts and...
I don't see how I can use a boom style engine hoist for the tranny, since my clutch went just after finishing an inside and outside body...
Not sure anyone will be willing to re-visit my clutch problems on my 52 Chevy, but let's see. I followed Nate's advice and opened up the...
Nate, just to be clear. If I take off that flywheel pan, without taking out tranny and clutch, I can do that cleaning that you describe, and see...
I am really wondering about that flywheel pan. I was up there looking, and the "pan" I saw, located just in front of the transmission, is held on...
Me again! Nate and company have given me a great, and hard, project taking out the clutch of my 52 Chevy (four on the floor). In some ways I'm...
Thanks I thought I posted this reply, but it doesn't seem to have registered. I just wanted to thank you guys for taking the time. What a...
You Guys are Great I am reminded over and over again what a great forum this is. Look at the extended responses, walking me through something I...
Ken, that is a great picture and shows me the motor mount right up close. But as I look at it, I'm not sure anything is wrong with my motor...
Clutch and Motor mounts I'll drive you guys crazy with these questions, so just stop answering when you see fit! My transmission is four speed...
Any thoughts on the proper material to purchase to put between the headliner and the truck roof? What I pulled off was very thin and so dried up...
I see the rear motor mounts in the Classic Parts catalogue -- simple looking piece of rubber -- but what's involved in getting them in and under...
Interesting.... I was told some time back that my rear motor mounts were not very good. How might that affect the clutch. And, dumb question,...
I knew when I got my 52 Truck back from its paint job that something mechanical would go wrong! To my untrained eye, my clutch is not engaging...
One more question By the way, when I am doing the flushing, and then running the engine to loosen up more of the stuff for further flushing, am I...
Thanks so much gang, as always! Eric
I know this is a stupid question. Nate advising me to flush the radiator until it runs clear. Does that mean opening the pet cock at the...
Separate names with a comma.
