I have a '66 Chevy K20 with factory running gear. It has the factory 8 lug rear axle. I am interested in installing dual wheels on the rear....
Give this a try: www.oldchevytruck.com I have sold a few of my '64-'66 Chevy trucks on this site. Good luck and hang on as long as you can....
Take a look at the 1960-1966 Chev/GMC Pickup Truck Factory Assembly manual. If you don't have one, you should get one. They run about $25.00....
I had a local automotive glass shop furnish and install a new windshield in my '66 K20 and my '65 C10. I had one used factory windshield and new...
I am interested in knowing what your VIN is. Can you post it? Thanks. Tony 4-5-6 Chevy Trucks
Gary: I have a few factory spare tire brackets that mount inside the drivers side bed side on a fleetside bed. Is this what you are looking...
The Thrift Air heater has the defrost control on the diffuser box, mounted below the dash, on the firewall. The Deluxe Air Heater/Defroster has...
According to the factory/manufacturer's literature, a factory sliding window was not availble on the C/K 10-30 series trucks. I have seen a few...
There are factory two speed wiper switches and factory two speed wiper motors on eBay all the time. I have bought and sold these items on eBay...
The harness from the firewall back to the rear cross sill will have three wires, one is green, one is brown and one is yellow. If it has a fourth...
Leyland: Looks like you are making some good progress. Hopefully, you can upload some pictures of your progress. Tony
A factory automatic tranny cross member from a '64-'66 Chevy truck works very nicely. I have installed a few of them on my '64-'66 Chevy trucks,...
I have a few good used swb fleetside bed sides. Let me know if I can help. I too, with someone would fabricate the swb and lwb fleetside bed sides.
You will have the same problem with a grille from a donor truck. I am installing a grille from one donor truck onto a grille support from another...
I have a few factory automatic steering columns with deluxe steering wheel & horn ring. Let me know if I can help. Tony 4-5-6 Chevy Trucks...
The sets are interchageable. When installing, make sure your get the long, slender keeper that attaches to the cab, behind the cab sail. It...
The pin is a friction fit. Pull the pin and insert a flat screw driver into the gap in the side of the pin, in order to open it up a bit. Prior...
George: I sent you PM regarding parts for your '66 Chevy C10. Let me know if I can help.
Remove the high pressure and low pressure hoses from the gear box. Put a container below the box to catch any ps fluid. With the engine off, try...
I used a cut-off wheel, as well, as dval suggested, however on a whim, I put a good metal blade in my recip saw and cut right through the factory...
Separate names with a comma.
